po: resync with source code

1 files changed, 95 insertions, 11 deletions

diff --git a/po/zh_TW/olsr.po b/po/zh_TW/olsr.po
index 1784de9f3..cb1220e06 100644
--- a/po/zh_TW/olsr.po
+++ b/po/zh_TW/olsr.po
@@ -35,17 +35,28 @@ msgstr "公告上傳"
 msgid "Announced network"
 msgstr "公告網路"
 
+msgid "Bad (ETX > 10)"
+msgstr ""
+
+msgid "Bad (SNR < 5)"
+msgstr ""
+
 msgid "Both values must use the dotted decimal notation."
 msgstr "這兩個值都必須採用點分十進位制格式"
 
 msgid "Broadcast address"
 msgstr "廣播位址"
 
+msgid "Can only be a valid IPv4 or IPv6 address or 'default'"
+msgstr ""
+
 msgid "Configuration"
 msgstr "設定"
 
-msgid "Device"
-msgstr "設備"
+msgid ""
+"Could not get any data. Make sure the jsoninfo plugin is installed and "
+"allows connections from localhost."
+msgstr ""
 
 msgid "Display"
 msgstr "顯示"
@@ -65,7 +76,9 @@ msgstr "啟用"
 msgid ""
 "Enable SmartGateway. If it is disabled, then all other SmartGateway "
 "parameters are ignored. Default is \"no\"."
-msgstr "啟用機動式匝道器. 假如它失效, 其它所有機動式匝道器參數將被忽視. 預設值是\"no\""
+msgstr ""
+"啟用機動式匝道器. 假如它失效, 其它所有機動式匝道器參數將被忽視. 預設值是\"no"
+"\""
 
 msgid "Enable this interface."
 msgstr "啟用這個介面"
@@ -87,9 +100,10 @@ msgid ""
 "value too, but does only update the hopcount if the nexthop changes too. "
 "Default is \"flat\"."
 msgstr ""
-"FIBMetric控制OLSR主機路由的公用路由計量設定.  \"flat\" 代表是公用計量數永遠是2. 這是較受歡迎的數值, "
-"因為它會協助linux核心路由清除舊的路由表. \"correct\"使用跳躍數當作公用路由計量. \"approx\"也使用跳躍數當作公用路由計量, "
-"但只作用在跳躍數也更新時. 預設值是\"flat\"."
+"FIBMetric控制OLSR主機路由的公用路由計量設定.  \"flat\" 代表是公用計量數永遠是"
+"2. 這是較受歡迎的數值, 因為它會協助linux核心路由清除舊的路由表. \"correct\"使"
+"用跳躍數當作公用路由計量. \"approx\"也使用跳躍數當作公用路由計量, 但只作用在"
+"跳躍數也更新時. 預設值是\"flat\"."
 
 msgid "Fisheye mechanism for TCs (checked means on). Default is \"on\""
 msgstr ""
@@ -103,6 +117,15 @@ msgstr "一般設定"
 msgid "General settings"
 msgstr "一般設定"
 
+msgid "Good (2 < ETX < 4)"
+msgstr ""
+
+msgid "Good (30 > SNR > 20)"
+msgstr ""
+
+msgid "Green"
+msgstr ""
+
 msgid "HNA"
 msgstr ""
 
@@ -124,6 +147,12 @@ msgstr ""
 msgid "Hello validity time"
 msgstr ""
 
+msgid "Hide IPv4"
+msgstr ""
+
+msgid "Hide IPv6"
+msgstr ""
+
 msgid "Hna4"
 msgstr ""
 
@@ -237,6 +266,14 @@ msgid ""
 "Default is \"2.5\"."
 msgstr ""
 
+msgid "Invalid Value for LQMult-Value. Must be between 0.01 and 1.0."
+msgstr ""
+
+msgid ""
+"Invalid Value for LQMult-Value. You must use a decimal number between 0.01 "
+"and 1.0 here."
+msgstr ""
+
 msgid "Known OLSR routes"
 msgstr ""
 
@@ -255,6 +292,11 @@ msgstr ""
 msgid "LQ level"
 msgstr ""
 
+msgid ""
+"LQMult requires two values (IP address or 'default' and multiplicator) "
+"seperated by space."
+msgstr ""
+
 msgid "Last hop"
 msgstr ""
 
@@ -316,8 +358,8 @@ msgid "Main IP"
 msgstr ""
 
 msgid ""
-"Make sure that OLSRd is running, the \"txtinfo\" plugin is loaded, "
-"configured on port 2006 and accepts connections from \"127.0.0.1\"."
+"Make sure that OLSRd is running, the \"jsoninfo\" plugin is loaded, "
+"configured on port 9090 and accepts connections from \"127.0.0.1\"."
 msgstr ""
 
 msgid "Metric"
@@ -328,7 +370,7 @@ msgstr ""
 
 msgid ""
 "Multiply routes with the factor given here. Allowed values are between 0.01 "
-"and 1. It is only used when LQ-Level is greater than 0. Examples:<br /"
+"and 1.0. It is only used when LQ-Level is greater than 0. Examples:<br /"
 ">reduce LQ to 192.168.0.1 by half: 192.168.0.1 0.5<br />reduce LQ to all "
 "nodes on this interface by 20%: default 0.8"
 msgstr ""
@@ -390,6 +432,9 @@ msgstr ""
 msgid "OLSR node"
 msgstr ""
 
+msgid "Orange"
+msgstr ""
+
 msgid "Overview"
 msgstr ""
 
@@ -432,6 +477,9 @@ msgstr ""
 msgid "Prefix"
 msgstr ""
 
+msgid "Red"
+msgstr ""
+
 msgid "Resolve"
 msgstr ""
 
@@ -453,6 +501,15 @@ msgid ""
 "IP of the first interface."
 msgstr ""
 
+msgid "Show IPv4"
+msgstr ""
+
+msgid "Show IPv6"
+msgstr ""
+
+msgid "Signal Noise Ratio in dB"
+msgstr ""
+
 msgid "SmartGW"
 msgstr ""
 
@@ -479,6 +536,12 @@ msgstr ""
 msgid "Status"
 msgstr ""
 
+msgid "Still usable (20 > SNR > 5)"
+msgstr ""
+
+msgid "Still usable (4 < ETX < 10)"
+msgstr ""
+
 msgid "Success rate of packages received from the neighbour"
 msgstr ""
 
@@ -532,8 +595,8 @@ msgid "Topology"
 msgstr ""
 
 msgid ""
-"Type of service value for the IP header of control traffic. Default is \"16"
-"\"."
+"Type of service value for the IP header of control traffic. Default is "
+"\"16\"."
 msgstr ""
 
 msgid "Unable to connect to the OLSR daemon!"
@@ -548,9 +611,18 @@ msgstr ""
 msgid "Use hysteresis"
 msgstr ""
 
+msgid "Validity Time"
+msgstr ""
+
 msgid "Version"
 msgstr ""
 
+msgid "Very good (ETX < 2)"
+msgstr ""
+
+msgid "Very good (SNR > 30)"
+msgstr ""
+
 msgid "WLAN"
 msgstr ""
 
@@ -580,3 +652,15 @@ msgstr ""
 
 msgid "Willingness"
 msgstr ""
+
+msgid "Yellow"
+msgstr ""
+
+msgid "no"
+msgstr ""
+
+msgid "yes"
+msgstr ""
+
+#~ msgid "Device"
+#~ msgstr "設備"