From 7beff3a82ef201c56f4b7a3fc5d06210865dbf9c Mon Sep 17 00:00:00 2001 From: Jo-Philipp Wich Date: Fri, 13 Jun 2014 09:41:23 +0000 Subject: po: resync with source code --- po/zh_TW/olsr.po | 106 +++++++++++++++++++++++++++++++++++++++++++++++++------ 1 file changed, 95 insertions(+), 11 deletions(-) (limited to 'po/zh_TW/olsr.po') diff --git a/po/zh_TW/olsr.po b/po/zh_TW/olsr.po index 1784de9f3..cb1220e06 100644 --- a/po/zh_TW/olsr.po +++ b/po/zh_TW/olsr.po @@ -35,17 +35,28 @@ msgstr "公告上傳" msgid "Announced network" msgstr "公告網路" +msgid "Bad (ETX > 10)" +msgstr "" + +msgid "Bad (SNR < 5)" +msgstr "" + msgid "Both values must use the dotted decimal notation." msgstr "這兩個值都必須採用點分十進位制格式" msgid "Broadcast address" msgstr "廣播位址" +msgid "Can only be a valid IPv4 or IPv6 address or 'default'" +msgstr "" + msgid "Configuration" msgstr "設定" -msgid "Device" -msgstr "設備" +msgid "" +"Could not get any data. Make sure the jsoninfo plugin is installed and " +"allows connections from localhost." +msgstr "" msgid "Display" msgstr "顯示" @@ -65,7 +76,9 @@ msgstr "啟用" msgid "" "Enable SmartGateway. If it is disabled, then all other SmartGateway " "parameters are ignored. Default is \"no\"." -msgstr "啟用機動式匝道器. 假如它失效, 其它所有機動式匝道器參數將被忽視. 預設值是\"no\"" +msgstr "" +"啟用機動式匝道器. 假如它失效, 其它所有機動式匝道器參數將被忽視. 預設值是\"no" +"\"" msgid "Enable this interface." msgstr "啟用這個介面" @@ -87,9 +100,10 @@ msgid "" "value too, but does only update the hopcount if the nexthop changes too. " "Default is \"flat\"." msgstr "" -"FIBMetric控制OLSR主機路由的公用路由計量設定. \"flat\" 代表是公用計量數永遠是2. 這是較受歡迎的數值, " -"因為它會協助linux核心路由清除舊的路由表. \"correct\"使用跳躍數當作公用路由計量. \"approx\"也使用跳躍數當作公用路由計量, " -"但只作用在跳躍數也更新時. 預設值是\"flat\"." +"FIBMetric控制OLSR主機路由的公用路由計量設定. \"flat\" 代表是公用計量數永遠是" +"2. 這是較受歡迎的數值, 因為它會協助linux核心路由清除舊的路由表. \"correct\"使" +"用跳躍數當作公用路由計量. \"approx\"也使用跳躍數當作公用路由計量, 但只作用在" +"跳躍數也更新時. 預設值是\"flat\"." msgid "Fisheye mechanism for TCs (checked means on). Default is \"on\"" msgstr "" @@ -103,6 +117,15 @@ msgstr "一般設定" msgid "General settings" msgstr "一般設定" +msgid "Good (2 < ETX < 4)" +msgstr "" + +msgid "Good (30 > SNR > 20)" +msgstr "" + +msgid "Green" +msgstr "" + msgid "HNA" msgstr "" @@ -124,6 +147,12 @@ msgstr "" msgid "Hello validity time" msgstr "" +msgid "Hide IPv4" +msgstr "" + +msgid "Hide IPv6" +msgstr "" + msgid "Hna4" msgstr "" @@ -237,6 +266,14 @@ msgid "" "Default is \"2.5\"." msgstr "" +msgid "Invalid Value for LQMult-Value. Must be between 0.01 and 1.0." +msgstr "" + +msgid "" +"Invalid Value for LQMult-Value. You must use a decimal number between 0.01 " +"and 1.0 here." +msgstr "" + msgid "Known OLSR routes" msgstr "" @@ -255,6 +292,11 @@ msgstr "" msgid "LQ level" msgstr "" +msgid "" +"LQMult requires two values (IP address or 'default' and multiplicator) " +"seperated by space." +msgstr "" + msgid "Last hop" msgstr "" @@ -316,8 +358,8 @@ msgid "Main IP" msgstr "" msgid "" -"Make sure that OLSRd is running, the \"txtinfo\" plugin is loaded, " -"configured on port 2006 and accepts connections from \"127.0.0.1\"." +"Make sure that OLSRd is running, the \"jsoninfo\" plugin is loaded, " +"configured on port 9090 and accepts connections from \"127.0.0.1\"." msgstr "" msgid "Metric" @@ -328,7 +370,7 @@ msgstr "" msgid "" "Multiply routes with the factor given here. Allowed values are between 0.01 " -"and 1. It is only used when LQ-Level is greater than 0. Examples:
reduce LQ to 192.168.0.1 by half: 192.168.0.1 0.5
reduce LQ to all " "nodes on this interface by 20%: default 0.8" msgstr "" @@ -390,6 +432,9 @@ msgstr "" msgid "OLSR node" msgstr "" +msgid "Orange" +msgstr "" + msgid "Overview" msgstr "" @@ -432,6 +477,9 @@ msgstr "" msgid "Prefix" msgstr "" +msgid "Red" +msgstr "" + msgid "Resolve" msgstr "" @@ -453,6 +501,15 @@ msgid "" "IP of the first interface." msgstr "" +msgid "Show IPv4" +msgstr "" + +msgid "Show IPv6" +msgstr "" + +msgid "Signal Noise Ratio in dB" +msgstr "" + msgid "SmartGW" msgstr "" @@ -479,6 +536,12 @@ msgstr "" msgid "Status" msgstr "" +msgid "Still usable (20 > SNR > 5)" +msgstr "" + +msgid "Still usable (4 < ETX < 10)" +msgstr "" + msgid "Success rate of packages received from the neighbour" msgstr "" @@ -532,8 +595,8 @@ msgid "Topology" msgstr "" msgid "" -"Type of service value for the IP header of control traffic. Default is \"16" -"\"." +"Type of service value for the IP header of control traffic. Default is " +"\"16\"." msgstr "" msgid "Unable to connect to the OLSR daemon!" @@ -548,9 +611,18 @@ msgstr "" msgid "Use hysteresis" msgstr "" +msgid "Validity Time" +msgstr "" + msgid "Version" msgstr "" +msgid "Very good (ETX < 2)" +msgstr "" + +msgid "Very good (SNR > 30)" +msgstr "" + msgid "WLAN" msgstr "" @@ -580,3 +652,15 @@ msgstr "" msgid "Willingness" msgstr "" + +msgid "Yellow" +msgstr "" + +msgid "no" +msgstr "" + +msgid "yes" +msgstr "" + +#~ msgid "Device" +#~ msgstr "設備" -- cgit v1.2.3