diff options
Diffstat (limited to 'modules/luci-base/po/en')
| -rw-r--r-- | modules/luci-base/po/en/base.po | 181 |
1 files changed, 71 insertions, 110 deletions
diff --git a/modules/luci-base/po/en/base.po b/modules/luci-base/po/en/base.po index 50a7c92815..5ff626f764 100644 --- a/modules/luci-base/po/en/base.po +++ b/modules/luci-base/po/en/base.po @@ -172,9 +172,6 @@ msgstr "" msgid "ADSL" msgstr "" -msgid "AICCU (SIXXS)" -msgstr "" - msgid "ANSI T1.413" msgstr "" @@ -211,9 +208,6 @@ msgstr "ATM device number" msgid "ATU-C System Vendor ID" msgstr "" -msgid "AYIYA" -msgstr "" - msgid "Access Concentrator" msgstr "Access Concentrator" @@ -317,11 +311,6 @@ msgstr "" msgid "Allowed IPs" msgstr "" -msgid "" -"Also see <a href=\"https://www.sixxs.net/faq/connectivity/?faq=comparison" -"\">Tunneling Comparison</a> on SIXXS" -msgstr "" - msgid "Always announce default router" msgstr "" @@ -400,11 +389,11 @@ msgstr "" msgid "Any zone" msgstr "Any zone" -msgid "Apply" -msgstr "Apply" +msgid "Apply request failed with status <code>%h</code>" +msgstr "" -msgid "Applying changes" -msgstr "Applying changes" +msgid "Apply unchecked" +msgstr "" msgid "" "Assign a part of given length of every public IPv6-prefix to this interface" @@ -510,9 +499,6 @@ msgstr "Bad address specified!" msgid "Band" msgstr "" -msgid "Behind NAT" -msgstr "" - msgid "" "Below is the determined list of files to backup. It consists of changed " "configuration files marked by opkg, essential base files and the user " @@ -584,12 +570,20 @@ msgstr "Changes" msgid "Changes applied." msgstr "Changes applied." +msgid "Changes have been reverted." +msgstr "" + msgid "Changes the administrator password for accessing the device" msgstr "Changes the administrator password for accessing the device" msgid "Channel" msgstr "Channel" +msgid "" +"Channel %d is not available in the %s regulatory domain and has been auto-" +"adjusted to %d." +msgstr "" + msgid "Check" msgstr "Check" @@ -668,12 +662,15 @@ msgstr "" msgid "Configuration" msgstr "Configuration" -msgid "Configuration applied." -msgstr "Configuration applied." - msgid "Configuration files will be kept." msgstr "Configuration files will be kept." +msgid "Configuration has been applied." +msgstr "" + +msgid "Configuration has been rolled back!" +msgstr "" + msgid "Confirmation" msgstr "Confirmation" @@ -686,12 +683,15 @@ msgstr "Connected" msgid "Connection Limit" msgstr "Connection Limit" -msgid "Connection to server fails when TLS cannot be used" -msgstr "" - msgid "Connections" msgstr "Connections" +msgid "" +"Could not regain access to the device after applying the configuration " +"changes. You might need to reconnect if you modified network related " +"settings such as the IP address or wireless security credentials." +msgstr "" + msgid "Country" msgstr "Country" @@ -820,9 +820,6 @@ msgstr "Default gateway" msgid "Default is stateless + stateful" msgstr "" -msgid "Default route" -msgstr "" - msgid "Default state" msgstr "Default state" @@ -865,6 +862,9 @@ msgstr "" msgid "Device unreachable" msgstr "" +msgid "Device unreachable!" +msgstr "" + msgid "Diagnostics" msgstr "Diagnostics" @@ -897,6 +897,9 @@ msgstr "" msgid "Discard upstream RFC1918 responses" msgstr "" +msgid "Dismiss" +msgstr "" + msgid "Displaying only packages containing" msgstr "" @@ -1151,6 +1154,9 @@ msgstr "" msgid "FT protocol" msgstr "" +msgid "Failed to confirm apply within %ds, waiting for rollback…" +msgstr "" + msgid "File" msgstr "" @@ -1344,9 +1350,6 @@ msgstr "Hang Up" msgid "Header Error Code Errors (HEC)" msgstr "" -msgid "Heartbeat" -msgstr "" - msgid "" "Here you can configure the basic aspects of your device like its hostname or " "the timezone." @@ -1461,9 +1464,6 @@ msgstr "" msgid "IPv6 address" msgstr "" -msgid "IPv6 address delegated to the local tunnel endpoint (optional)" -msgstr "" - msgid "IPv6 assignment hint" msgstr "" @@ -2039,9 +2039,6 @@ msgstr "" msgid "NTP server candidates" msgstr "" -msgid "NTP sync time-out" -msgstr "" - msgid "Name" msgstr "Name" @@ -2165,6 +2162,9 @@ msgstr "" msgid "Obfuscated Password" msgstr "" +msgid "Obtain IPv6-Address" +msgstr "" + msgid "Off-State Delay" msgstr "" @@ -2216,12 +2216,6 @@ msgstr "" msgid "Optional" msgstr "" -msgid "Optional, specify to override default server (tic.sixxs.net)" -msgstr "" - -msgid "Optional, use when the SIXXS account has more than one tunnel" -msgstr "" - msgid "" "Optional. 32-bit mark for outgoing encrypted packets. Enter value in hex, " "starting with <code>0x</code>." @@ -2682,9 +2676,6 @@ msgstr "" msgid "Request IPv6-prefix of length" msgstr "" -msgid "Require TLS" -msgstr "" - msgid "Required" msgstr "" @@ -2743,6 +2734,15 @@ msgstr "" msgid "Revert" msgstr "Revert" +msgid "Revert changes" +msgstr "" + +msgid "Revert request failed with status <code>%h</code>" +msgstr "" + +msgid "Reverting configuration…" +msgstr "" + msgid "Root" msgstr "" @@ -2758,9 +2758,6 @@ msgstr "" msgid "Route type" msgstr "" -msgid "Routed IPv6 prefix for downstream interfaces" -msgstr "" - msgid "Router Advertisement-Service" msgstr "" @@ -2786,14 +2783,6 @@ msgstr "" msgid "SHA256" msgstr "" -msgid "" -"SIXXS supports TIC only, for static tunnels using IP protocol 41 (RFC4213) " -"use 6in4 instead" -msgstr "" - -msgid "SIXXS-handle[/Tunnel-ID]" -msgstr "" - msgid "SNR" msgstr "" @@ -2821,9 +2810,6 @@ msgstr "Save" msgid "Save & Apply" msgstr "Save & Apply" -msgid "Save & Apply" -msgstr "" - msgid "Scan" msgstr "Scan" @@ -2850,17 +2836,6 @@ msgstr "Separate Clients" msgid "Server Settings" msgstr "" -msgid "Server password" -msgstr "" - -msgid "" -"Server password, enter the specific password of the tunnel when the username " -"contains the tunnel ID" -msgstr "" - -msgid "Server username" -msgstr "" - msgid "Service Name" msgstr "" @@ -2953,9 +2928,6 @@ msgstr "" msgid "Source" msgstr "Source" -msgid "Source routing" -msgstr "" - msgid "Specifies the directory the device is attached to" msgstr "" @@ -2994,6 +2966,9 @@ msgstr "Start" msgid "Start priority" msgstr "Start priority" +msgid "Starting configuration apply…" +msgstr "" + msgid "Startup" msgstr "" @@ -3144,6 +3119,16 @@ msgid "The configuration file could not be loaded due to the following error:" msgstr "" msgid "" +"The device could not be reached within %d seconds after applying the pending " +"changes, which caused the configuration to be rolled back for safety " +"reasons. If you believe that the configuration changes are correct " +"nonetheless, perform an unchecked configuration apply. Alternatively, you " +"can dismiss this warning and edit changes before attempting to apply again, " +"or revert all pending changes to keep the currently working configuration " +"state." +msgstr "" + +msgid "" "The device file of the memory or partition (<abbr title=\"for example\">e.g." "</abbr> <code>/dev/sda1</code>)" msgstr "" @@ -3165,9 +3150,6 @@ msgid "" "\"Proceed\" below to start the flash procedure." msgstr "" -msgid "The following changes have been committed" -msgstr "" - msgid "The following changes have been reverted" msgstr "The following changes have been reverted" @@ -3226,11 +3208,6 @@ msgstr "" "settings." msgid "" -"The tunnel end-point is behind NAT, defaults to disabled and only applies to " -"AYIYA" -msgstr "" - -msgid "" "The uploaded image file does not contain a supported format. Make sure that " "you choose the generic image format for your platform." msgstr "" @@ -3240,7 +3217,7 @@ msgstr "" msgid "There are no active leases." msgstr "" -msgid "There are no pending changes to apply!" +msgid "There are no changes to apply." msgstr "" msgid "There are no pending changes to revert!" @@ -3379,15 +3356,6 @@ msgstr "" msgid "Tunnel Link" msgstr "" -msgid "Tunnel broker protocol" -msgstr "" - -msgid "Tunnel setup server" -msgstr "" - -msgid "Tunnel type" -msgstr "" - msgid "Tx-Power" msgstr "" @@ -3560,12 +3528,6 @@ msgstr "" msgid "Vendor Class to send when requesting DHCP" msgstr "" -msgid "Verbose" -msgstr "" - -msgid "Verbose logging by aiccu daemon" -msgstr "" - msgid "Verify" msgstr "" @@ -3597,16 +3559,15 @@ msgstr "" "WPA-Encryption requires wpa_supplicant (for client mode) or hostapd (for AP " "and ad-hoc mode) to be installed." -msgid "" -"Wait for NTP sync that many seconds, seting to 0 disables waiting (optional)" -msgstr "" - msgid "Waiting for changes to be applied..." msgstr "" msgid "Waiting for command to complete..." msgstr "" +msgid "Waiting for configuration to get applied… %ds" +msgstr "" + msgid "Waiting for device..." msgstr "" @@ -3621,12 +3582,6 @@ msgid "" "communications" msgstr "" -msgid "Whether to create an IPv6 default route over the tunnel" -msgstr "" - -msgid "Whether to route only packets from delegated prefixes" -msgstr "" - msgid "Width" msgstr "" @@ -3767,9 +3722,6 @@ msgstr "" msgid "local <abbr title=\"Domain Name System\">DNS</abbr> file" msgstr "local <abbr title=\"Domain Name System\">DNS</abbr> file" -msgid "minimum 1280, maximum 1480" -msgstr "" - msgid "minutes" msgstr "" @@ -3845,6 +3797,15 @@ msgstr "" msgid "« Back" msgstr "« Back" +#~ msgid "Apply" +#~ msgstr "Apply" + +#~ msgid "Applying changes" +#~ msgstr "Applying changes" + +#~ msgid "Configuration applied." +#~ msgstr "Configuration applied." + #~ msgid "Action" #~ msgstr "Action" |