Age | Commit message (Collapse) | Author |
|
The RFC for icmpv6 specifies that an errant packet should be included
in the returned ICMP packet, and that it should include up to the amount
needed to fill the minimum MTU (1280 bytes) if possible. The current code
included the Link header in that calculation but the RFC is referring
to the IP MTU not the link MTU. Some conformance tests check this and
report an error agains the stack for this.
The full header length shoudl however continue to be used when allocating
header space.
Make the same change for IPv4 for consistency.
Add a test for icmp payload sizing.
Test that the included data in an ICMP error packet conforms to the
requirements of RFC 972, RFC 4443 section 2.4 and RFC 1812 Section 4.3.2.3.
Fixes #5311
PiperOrigin-RevId: 353790203
|
|
The ARP stat NetworkUnreachable was removed, and was replaced by
InterfaceHasNoLocalAddress. No stats are recorded when dealing with an
missing endpoint (ErrNotConnected) (because if there is no endpoint,
there is no valid per-endpoint stats).
PiperOrigin-RevId: 353759462
|
|
PiperOrigin-RevId: 353755271
|
|
PiperOrigin-RevId: 353697719
|
|
Rewrite tcp.endpoint.Write to avoid manual locking and unlocking. This should
prevent similar mistakes in the future.
PiperOrigin-RevId: 353675734
|
|
It previously returned an error but it could only be UnknownNICID. It now
returns a boolean to indicate whether the nic exists or not.
PiperOrigin-RevId: 353337489
|
|
PiperOrigin-RevId: 353336894
|
|
The route resolution callback will be called with a
stack.ResolvedFieldsResult which will hold the route info so callers
can avoid attempting resolution again to check if a previous resolution
attempt succeeded or not.
Test: integration_test.TestRouteResolvedFields
PiperOrigin-RevId: 353319019
|
|
Fixes #5113.
PiperOrigin-RevId: 353313374
|
|
Fixes #1509.
PiperOrigin-RevId: 353295589
|
|
Atomic operations here significantly slow down gVisor builds with
kcov/coverage enabled. Also mark these functions go:norace to avoid
complaints from the race detector.
PiperOrigin-RevId: 353281865
|
|
If a network address has a static mapping to a link address, calculate
it in GetLinkAddress.
Test: stack_test.TestStaticGetLinkAddress
PiperOrigin-RevId: 353179616
|
|
We have support for the output interface name, but not for the input
interface name.
This change adds the support for the input interface name, and adds the
test cases for it.
Fixes #5300
PiperOrigin-RevId: 353179389
|
|
GetLinkAddress's callback will be called immediately with a
stack.LinkResolutionResult which will hold the link address
so no need to also return the link address from the function.
Fixes #5151.
PiperOrigin-RevId: 353157857
|
|
...unless explicitly requested via ResolveWith.
Remove cancelled channels from pending packets as we can use the link
resolution channel in a FIFO to limit the number of maximum pending
resolutions we should queue packets for.
This change also defers starting the goroutine that handles link
resolution completion to when link resolution succeeds, fails or
gets cancelled due to the max number of pending resolutions being
reached.
Fixes #751.
PiperOrigin-RevId: 353130577
|
|
Test: integration_test.TestWritePacketsLinkResolution
Fixes #4458.
PiperOrigin-RevId: 353108826
|
|
fdbased and qdisc layers expect these fields to already be
populated before being reached.
PiperOrigin-RevId: 353099492
|
|
PiperOrigin-RevId: 352954044
|
|
- Removes the unimplemented message for SO_LINGER
- Fix the length for IP_PKTINFO option
PiperOrigin-RevId: 352917611
|
|
PiperOrigin-RevId: 352908368
|
|
PiperOrigin-RevId: 352904728
|
|
Fixes #5263
PiperOrigin-RevId: 352903844
|
|
PiperOrigin-RevId: 352894106
|
|
The error messages are not needed or used as these are not processing errors
so much as errors to be reported back to the packet sender. Implicitly
describe whether each error should generate ICMP packets or not. Most do
but there are a couple that do not.
Slightly alter some test expectations for Linux compatibility and add a
couple more. Improve Linux compatibility on error packet returns. Some
cosmetic changes to tests to match the upcoming packet impact version
of the same tests.
PiperOrigin-RevId: 352889785
|
|
Link addresses are cached on a per NIC basis so instead of having a
single cache that includes the NIC ID for neighbor entry lookups,
use a single cache per NIC.
PiperOrigin-RevId: 352684111
|
|
On ARM64, when ptrace stops on a system call, it uses the x7 register to
indicate whether the stop has been signalled from syscall entry or syscall
exit. This means that we can't get a value of this register and we can't change
it. More details are in the comment for tracehook_report_syscall in
arch/arm64/kernel/ptrace.c.
This happens only if we stop on a system call, so let's queue a signal, resume
a stub thread and catch it on a signal handling.
Fixes: #5238
PiperOrigin-RevId: 352668695
|
|
To facilitate the debugging of multi-homed setup, track Network
protocols statistics for each endpoint. Note that the original
stack-wide stats still exist.
A new type of statistic counter is introduced, which track two
versions of a stat at the same time. This lets a network endpoint
increment both the local stat and the stack-wide stat at the same
time.
Fixes #4605
PiperOrigin-RevId: 352663276
|
|
PiperOrigin-RevId: 352623277
|
|
Packets may be pending on link resolution to complete before being sent.
Link resolution is performed for neighbors which are unique to a NIC so
hold link resolution related state under the NIC, not the stack.
Note, this change may result in more queued packets but that is okay as
RFC 4861 section 7.2.2 recommends that the stack maintain a queue of
packets for each neighbor that is waiting for link resolution to
complete, not a fixed limit per stack.
PiperOrigin-RevId: 352322155
|
|
If a Route is being created through a link that requires link address
resolution and a remote address that has a known mapping to a link
address, populate the link address when the route is created.
This removes the need for neighbor/link address caches to perform this
check.
Fixes #5149
PiperOrigin-RevId: 352122401
|
|
Test: integration_test.TestGetLinkAddress
PiperOrigin-RevId: 352119404
|
|
stack.Route is used to send network packets and resolve link addresses.
A LinkEndpoint does not need to do either of these and only needs the
route's fields at the time of the packet write request.
Since LinkEndpoints only need the route's fields when writing packets,
pass a stack.RouteInfo instead.
PiperOrigin-RevId: 352108405
|
|
The same intent can be specified via the io.Writer.
PiperOrigin-RevId: 352098747
|
|
This change implements TLP details enumerated in
https://tools.ietf.org/html/draft-ietf-tcpm-rack-08#section-7.5.2.
Fixes #5084
PiperOrigin-RevId: 352093473
|
|
IPv4 previously accepts the packet, while IPv6 panics. Neither is the behavior
in Linux.
splice() in Linux has different behavior than in gVisor. This change documents
it in the SpliceTooLong test.
Reported-by: syzbot+b550e78e5c24d1d521f2@syzkaller.appspotmail.com
PiperOrigin-RevId: 352091286
|
|
We loop over the list of packets anyways so setting these aren't
expensive.
Now that they are populated only by the link endpoint that uses them,
TCP does not need to.
PiperOrigin-RevId: 352090853
|
|
Otherwise, races can occur between concurrent logs.
PiperOrigin-RevId: 352086914
|
|
io.Writer.Write requires err to be non-nil if n < len(v).
We could allow this but it will be irreversible if users depend on this
behavior.
Ported the test that discovered this.
PiperOrigin-RevId: 352065946
|
|
PiperOrigin-RevId: 352032380
|
|
- Remove the pipe package's dependence on the buffer package, which becomes
unused as a result. The buffer package is currently intended to serve two use
cases, pipes and temporary buffers, and does neither optimally as a result;
this change facilitates retooling the buffer package to better serve the
latter.
- Pass callbacks taking safemem.BlockSeq to the internal pipe I/O methods,
which makes most callbacks trivial.
- Fix VFS1's splice() and tee() to immediately return if a pipe returns a
partial write.
PiperOrigin-RevId: 351911375
|
|
Fixes #4963
Startblock:
has LGTM from sbalana
and then
add reviewer ghanan
PiperOrigin-RevId: 351886320
|
|
Return EEXIST when overwritting a file as long as the caller has exec
permission on the parent directory, even if the caller doesn't have
write permission.
Also reordered the mount write check, which happens before permission
is checked.
Closes #5164
PiperOrigin-RevId: 351868123
|
|
Commit 25b5ec7 moved link address resolution out of the transport layer;
special handling of link address resolution is no longer necessary in tcp.
PiperOrigin-RevId: 351839254
|
|
Note, this includes static entries to match linux's behaviour.
```
$ ip neigh show dev eth0
192.168.42.1 lladdr fc:ec:da:70:6e:f9 STALE
$ sudo ip neigh add 192.168.42.172 lladdr 22:33:44:55:66:77 dev eth0
$ ip neigh show dev eth0
192.168.42.1 lladdr fc:ec:da:70:6e:f9 STALE
192.168.42.172 lladdr 22:33:44:55:66:77 PERMANENT
$ sudo ifconfig eth0 down
$ ip neigh show dev eth0
$ sudo ifconfig eth0 up
$ ip neigh show dev eth0
```
Test: stack_test.TestClearNeighborCacheOnNICDisable
PiperOrigin-RevId: 351696306
|
|
Link address resolution is performed at the link layer (if required) so
we can defer it from the transport layer. When link resolution is
required, packets will be queued and sent once link resolution
completes. If link resolution fails, the transport layer will receive a
control message indicating that the stack failed to route the packet.
tcpip.Endpoint.Write no longer returns a channel now that writes do not
wait for link resolution at the transport layer.
tcpip.ErrNoLinkAddress is no longer used so it is removed.
Removed calls to stack.Route.ResolveWith from the transport layer so
that link resolution is performed when a route is created in response
to an incoming packet (e.g. to complete TCP handshakes or send a RST).
Tests:
- integration_test.TestForwarding
- integration_test.TestTCPLinkResolutionFailure
Fixes #4458
RELNOTES: n/a
PiperOrigin-RevId: 351684158
|
|
Whether the variable was found is already returned by syscall.Getenv.
os.Getenv drops this value while os.Lookupenv passes it along.
PiperOrigin-RevId: 351674032
|
|
This is useful when using the shell library in order to log to both the test
log and the standard logs.
PiperOrigin-RevId: 351673465
|
|
|
|
|
|
PiperOrigin-RevId: 351638451
|