Age | Commit message (Collapse) | Author |
|
- Wrap NIC's fields that should only be accessed while holding the mutex in
an anonymous struct with the embedded mutex.
- Make sure NIC's spoofing and promiscuous mode flags are only read while
holding the NIC's mutex.
- Use the correct endpoint when sending DAD messages.
- Do not hold the NIC's lock when sending DAD messages.
This change does not introduce any behaviour changes.
Tests: Existing tests continue to pass.
PiperOrigin-RevId: 291036251
|
|
*net.UDPAddr
PacketConn.LocalAddr() already returns *net.UDPAddr correctly.
|
|
PiperOrigin-RevId: 290840370
|
|
Such a stat accounts for all connections that are currently
established and not yet transitioned to close state.
Also fix bug in double increment of CurrentEstablished stat.
Fixes #1579
PiperOrigin-RevId: 290827365
|
|
PiperOrigin-RevId: 290793754
|
|
CERT Advisory CA-96.21 III. Solution advises that devices drop packets which
could not have correctly arrived on the wire, such as receiving a packet where
the source IP address is owned by the device that sent it.
Fixes #1507
PiperOrigin-RevId: 290378240
|
|
It was possible to use this function incorrectly, and its separation
wasn't buying us anything.
PiperOrigin-RevId: 290311100
|
|
If a previously added IPv6 address (statically or via SLAAC) was removed, it
would be left in an expired state waiting to be cleaned up if any references to
it were still held. During this time, the same address could be regenerated via
SLAAC, which should be allowed. This change supports this scenario.
When upgrading an endpoint from temporary or permanentExpired to permanent,
respect the new configuration type (static or SLAAC) and deprecated status,
along with the new PrimaryEndpointBehavior (which was already supported).
Test: stack.TestAutoGenAddrAfterRemoval
PiperOrigin-RevId: 289990168
|
|
This change adds support to send NDP Router Solicitation messages when a NIC
becomes enabled as a host, as per RFC 4861 section 6.3.7.
Note, Router Solicitations will only be sent when the stack has forwarding
disabled.
Tests: Unittests to make sure that the initial Router Solicitations are sent
as configured. The tests also validate the sent Router Solicitations' fields.
PiperOrigin-RevId: 289964095
|
|
The change to introduce worker goroutines can cause the endpoint
to transition to StateError and we should terminate the loop rather
than let the endpoint transition to a CLOSED state as we do
in case the endpoint enters TIME-WAIT/CLOSED. Moving to a closed
state would cause the actual error to not be propagated to
any read() calls etc.
PiperOrigin-RevId: 289923568
|
|
|
|
All inbound segments for connections in ESTABLISHED state are delivered to the
endpoint's queue but for every segment delivered we also queue the endpoint for
processing to a selected processor. This ensures that when there are a large
number of connections in ESTABLISHED state the inbound packets are all handled
by a small number of goroutines and significantly reduces the amount of work the
goscheduler has to perform.
We let connections in other states follow the current path where the
endpoint's goroutine directly handles the segments.
Updates #231
PiperOrigin-RevId: 289728325
|
|
PiperOrigin-RevId: 289718534
|
|
Do Source Address Selection when choosing an IPv6 source address as per RFC 6724
section 5 rules 1-3:
1) Prefer same address
2) Prefer appropriate scope
3) Avoid deprecated addresses.
A later change will update Source Address Selection to follow rules 4-8.
Tests:
Rule 1 & 2: stack.TestIPv6SourceAddressSelectionScopeAndSameAddress,
Rule 3: stack.TestAutoGenAddrTimerDeprecation,
stack.TestAutoGenAddrDeprecateFromPI
PiperOrigin-RevId: 289559373
|
|
|
|
Fixes #1490
Fixes #1495
PiperOrigin-RevId: 289523250
|
|
|
|
PiperOrigin-RevId: 289479774
|
|
PiperOrigin-RevId: 289169518
|
|
CancellableTimer tests were in a timer_test package but lived within the
tcpip directory. This caused issues with go tools.
PiperOrigin-RevId: 289166345
|
|
|
|
This is a band-aid fix for now to prevent panics.
PiperOrigin-RevId: 289078453
|
|
* Rename syncutil to sync.
* Add aliases to sync types.
* Replace existing usage of standard library sync package.
This will make it easier to swap out synchronization primitives. For example,
this will allow us to use primitives from github.com/sasha-s/go-deadlock to
check for lock ordering violations.
Updates #1472
PiperOrigin-RevId: 289033387
|
|
PiperOrigin-RevId: 289019953
|
|
Inform the Stack's NDPDispatcher when it receives an NDP Router Advertisement
that updates the available configurations via DHCPv6. The Stack makes sure that
its NDPDispatcher isn't informed unless the avaiable configurations via DHCPv6
for a NIC is updated.
Tests: Test that a Stack's NDPDispatcher is informed when it receives an NDP
Router Advertisement that informs it of new configurations available via DHCPv6.
PiperOrigin-RevId: 289001283
|
|
Internal tools timeout after 60s during tests that are required to pass before
changes can be submitted. Separate out NDP tests into its own package to help
prevent timeouts when testing.
PiperOrigin-RevId: 288990597
|
|
This makes it possible to call the sockopt from go even when the NIC has no
name.
PiperOrigin-RevId: 288955236
|
|
...retrievable later via stack.NICInfo().
Clients of this library can use it to add metadata that should be tracked
alongside a NIC, to avoid having to keep a map[tcpip.NICID]metadata mirroring
stack.Stack's nic map.
PiperOrigin-RevId: 288924900
|
|
|
|
Add a new CancellableTimer type to encapsulate the work of safely stopping
timers when it fires at the same time some "related work" is being handled. The
term "related work" is some work that needs to be done while having obtained
some common lock (L).
Example: Say we have an invalidation timer that may be extended or cancelled by
some event. Creating a normal timer and simply cancelling may not be sufficient
as the timer may have already fired when the event handler attemps to cancel it.
Even if the timer and event handler obtains L before doing work, once the event
handler releases L, the timer will eventually obtain L and do some unwanted
work.
To prevent the timer from doing unwanted work, it checks if it should early
return instead of doing the normal work after obtaining L. When stopping the
timer callers must have L locked so the timer can be safely informed that it
should early return.
Test: Tests that CancellableTimer fires and resets properly. Test to make sure
the timer fn is not called after being stopped within the lock L.
PiperOrigin-RevId: 288806984
|
|
|
|
ending up with the wrong chains and is indexing -1 into rules.
|
|
...and port V6OnlyOption to it.
PiperOrigin-RevId: 288789451
|
|
PiperOrigin-RevId: 288779416
|
|
|
|
PiperOrigin-RevId: 288772878
|
|
|
|
|
|
PacketLooping is already a member on the passed Route.
PiperOrigin-RevId: 288721500
|
|
This gets us closer to passing the iptables tests and opens up iptables
so it can be worked on by multiple people.
A few restrictions are enforced for security (i.e. we don't want to let
users write a bunch of iptables rules and then just not enforce them):
- Only the filter table is writable.
- Only ACCEPT rules with no matching criteria can be added.
|
|
...enabling us to remove the "CreateNamedLoopbackNIC" variant of
CreateNIC and all the plumbing to connect it through to where the value
is read in FindRoute.
PiperOrigin-RevId: 288713093
|
|
Before, each of small read()'s that raises window either from zero
or above threshold of aMSS, would generate an ACK. In a classic
silly-window-syndrome scenario, we can imagine a pessimistic case
when small read()'s generate a stream of ACKs.
This PR fixes that, essentially treating window size < aMSS as zero.
We send ACK exactly in a moment when window increases to >= aMSS
or half of receive buffer size (whichever smaller).
|
|
Support deprecating network endpoints on a NIC. If an endpoint is deprecated, it
should not be used for new connections unless a more preferred endpoint is not
available, or unless the deprecated endpoint was explicitly requested.
Test: Test that deprecated endpoints are only returned when more preferred
endpoints are not available and SLAAC addresses are deprecated after its
preferred lifetime
PiperOrigin-RevId: 288562705
|
|
When receiving data, netstack avoids sending spurious acks. When
user does recv() should netstack send ack telling the sender that
the window was increased? It depends. Before this patch, netstack
_will_ send the ack in the case when window was zero or window >>
scale was zero. Basically - when recv space increased from zero.
This is not working right with silly-window-avoidance on the sender
side. Some network stacks refuse to transmit segments, that will fill
the window but are below MSS. Before this patch, this confuses
netstack. On one hand if the window was like 3 bytes, netstack
will _not_ send ack if the window increases. On the other hand
sending party will refuse to transmit 3-byte packet.
This patch changes that, making netstack will send an ACK when
the available buffer size increases to or above 1*MSS. This will
inform other party buffer is large enough, and hopefully uncork it.
Signed-off-by: Marek Majkowski <marek@cloudflare.com>
|
|
Test: Test that an IPv6 link-local address is not auto-generated for loopback
NICs, even when it is enabled for non-loopback NICS.
PiperOrigin-RevId: 288519591
|
|
Pass the NIC-internal name to the NIC name function when generating opaque IIDs
so implementations can use the name that was provided when the NIC was created.
Previously, explicit NICID to NIC name resolution was required from the netstack
integrator.
Tests: Test that the name provided when creating a NIC is passed to the NIC name
function when generating opaque IIDs.
PiperOrigin-RevId: 288395359
|
|
Support using opaque interface identifiers when generating IPv6 addresses via
SLAAC when configured to do so.
Note, this change does not handle retries in response to DAD conflicts yet.
That will also come in a later change.
Test: Test that when SLAAC addresses are generated, they use opaque interface
identifiers when configured to do so.
PiperOrigin-RevId: 288078605
|
|
Support generating opaque interface identifiers as defined by RFC 7217 for
auto-generated IPv6 link-local addresses. Opaque interface identifiers will also
be used for IPv6 addresses auto-generated via SLAAC in a later change.
Note, this change does not handle retries in response to DAD conflicts yet.
That will also come in a later change.
Tests: Test that when configured to generated opaque IIDs, they are properly
generated as outlined by RFC 7217.
PiperOrigin-RevId: 288035349
|
|
|
|
PiperOrigin-RevId: 287217899
|