| Age | Commit message (Collapse) | Author |
|---|
|
|
|
PiperOrigin-RevId: 319770124
|
|
|
|
Avoid a race where an arbitrary goroutine scheduling delay can cause the
processor to miss events and hang indefinitely.
Reduce allocations by storing processors by-value in the dispatcher, and
by using a single WaitGroup rather than one per processor.
PiperOrigin-RevId: 319665861
|
|
|
|
The application can choose to initiate a non-blocking connect and
later block on a read, when the endpoint is still in SYN-SENT state.
PiperOrigin-RevId: 319311016
|
|
|
|
a) When GSO is in use we should not cap the segment to maxPayloadSize in
sender.maybeSendSegment as the GSO logic will cap the segment to the correct
size. Without this the host GSO is not used as we end up breaking up large
segments into small MSS sized segments before writing the packets to the
host.
b) The check to not split a segment due to it not fitting in the receiver window
when there are pending segments is incorrect as segments in writeList can be
really large as we just take the write call's buffer size and create a single
large segment. So a write of say 128KB will just be 1 segment in the
writeList.
The linux code checks if 1 MSS sized segments fits in the receiver's window
and if not then does not split the current segment. gVisor's check was
incorrect that it was checking if the whole segment which could be >>> 1 MSS
would fit in the receiver's window. This was causing us to prematurely stop
sending and falling back to retransmit timer/probe from the other end to send
data.
This was seen when running HTTPD benchmarks where @ HEAD when sending large
files the benchmark was taking forever to run.
The tcp_splitseg_mss_test.go is being deleted as the test as written doesn't
test what is intended correctly. This is because GSO is enabled by default and
the reason the MSS+1 sized segment is sent is because GSO is in use. A proper
test will require disabling GSO on linux and netstack which is going to take a
bit of work in packetimpact to do it correctly.
Separately a new test probably should be written that verifies that a segment >
availableWindow is not split if the availableWindow is < 1 MSS.
Fixes #3107
PiperOrigin-RevId: 319172089
|
|
|
|
...by calling (*tcp.endpoint).EndpointState only once when possible.
Avoid wrapping (*sleep.Waker).Assert in a useless func while I'm here.
PiperOrigin-RevId: 319074149
|
|
|
|
IPv6 raw sockets never include the IPv6 header.
PiperOrigin-RevId: 318582989
|
|
|
|
SO_NO_CHECK is used to skip the UDP checksum generation on a TX socket
(UDP checksum is optional on IPv4).
Test:
- TestNoChecksum
- SoNoCheckOffByDefault (UdpSocketTest)
- SoNoCheck (UdpSocketTest)
Fixes #3055
PiperOrigin-RevId: 318575215
|
|
|
|
- Split connTrackForPacket into 2 functions instead of switching on flag
- Replace hash with struct keys.
- Remove prefixes where possible
- Remove unused connStatus, timeout
- Flatten ConnTrack struct a bit - some intermediate structs had no meaning
outside of the context of their parent.
- Protect conn.tcb with a mutex
- Remove redundant error checking (e.g. when is pkt.NetworkHeader valid)
- Clarify that HandlePacket and CreateConnFor are the expected entrypoints for
ConnTrack
PiperOrigin-RevId: 318407168
|
|
|
|
Linux controls socket send/receive buffers using a few sysctl variables
- net.core.rmem_default
- net.core.rmem_max
- net.core.wmem_max
- net.core.wmem_default
- net.ipv4.tcp_rmem
- net.ipv4.tcp_wmem
The first 4 control the default socket buffer sizes for all sockets
raw/packet/tcp/udp and also the maximum permitted socket buffer that can be
specified in setsockopt(SOL_SOCKET, SO_(RCV|SND)BUF,...).
The last two control the TCP auto-tuning limits and override the default
specified in rmem_default/wmem_default as well as the max limits.
Netstack today only implements tcp_rmem/tcp_wmem and incorrectly uses it
to limit the maximum size in setsockopt() as well as uses it for raw/udp
sockets.
This changelist introduces the other 4 and updates the udp/raw sockets to use
the newly introduced variables. The values for min/max match the current
tcp_rmem/wmem values and the default value buffers for UDP/RAW sockets is
updated to match the linux value of 212KiB up from the really low current value
of 32 KiB.
Updates #3043
Fixes #3043
PiperOrigin-RevId: 318089805
|
|
|
|
|
|
For TCP sockets, SO_REUSEADDR relaxes the rules for binding addresses.
gVisor/netstack already supported a behavior similar to SO_REUSEADDR, but did
not allow disabling it. This change brings the SO_REUSEADDR behavior closer to
the behavior implemented by Linux and adds a new SO_REUSEADDR disabled
behavior. Like Linux, SO_REUSEADDR is now disabled by default.
PiperOrigin-RevId: 317984380
|
|
|
|
... and unify logic for detached netsted endpoints.
sniffer.go caused crashes if a packet delivery is attempted when the dispatcher
is nil.
Extracted the endpoint nesting logic into a common composable type so it can be
used by the Fuchsia Netstack (the pattern is widespread there).
PiperOrigin-RevId: 317682842
|
|
|
|
Test:
- TestIncrementChecksumErrors
Fixes #2943
PiperOrigin-RevId: 317348158
|
|
|
|
Users that never set iptables rules shouldn't incur the iptables performance
cost. Suggested by Ian (@iangudger).
PiperOrigin-RevId: 317232921
|
|
|
|
Metadata was useful for debugging and safety, but enough tests exist that we
should see failures when (de)serialization is broken. It made stack
initialization more cumbersome and it's also getting in the way of ip6tables.
PiperOrigin-RevId: 317210653
|
|
|
|
Updates #173,#6
Fixes #2888
PiperOrigin-RevId: 317087652
|
|
|
|
When a tcp.timer or tcpip.Route is no longer used, clean up its
resources so that unused memory may be released.
PiperOrigin-RevId: 317046582
|
|
... to help reduce flakes.
When waiting for an event to occur, use a timeout of 10s. When waiting
for an event to not occur, use a timeout of 1s.
Test: Ran test locally w/ run count of 1000 with and without gotsan.
PiperOrigin-RevId: 316998128
|
|
|
|
Ensure that CurrentConnected stat is updated on any errors and cleanups
during connected state processing.
Fixes #2968
PiperOrigin-RevId: 316919426
|
|
PiperOrigin-RevId: 316767969
|
|
|
|
In passive open cases, we transition to Established state after
initializing endpoint's sender and receiver. With this we lose out
on any updates coming from the ACK that completes the handshake.
This change ensures that we uniformly transition to Established in all
cases and does minor cleanups.
Fixes #2938
PiperOrigin-RevId: 316567014
|
|
|
|
I am not really sure what the point of this is, but someone filed a bug about
it, so I assume something relies on it.
PiperOrigin-RevId: 316225127
|
|
|
|
Tentative addresses should not be used when finding a route. This change
fixes a bug where a tentative address may have been used.
Test: stack_test.TestDADResolve
PiperOrigin-RevId: 315997624
|
|
|
|
On UDP sockets, SO_REUSEADDR allows multiple sockets to bind to the same
address, but only delivers packets to the most recently bound socket. This
differs from the behavior of SO_REUSEADDR on TCP sockets. SO_REUSEADDR for TCP
sockets will likely need an almost completely independent implementation.
SO_REUSEADDR has some odd interactions with the similar SO_REUSEPORT. These
interactions are tested fairly extensively and all but one particularly odd
one (that honestly seems like a bug) behave the same on gVisor and Linux.
PiperOrigin-RevId: 315844832
|
|
|
|
Minimum header sizes are already checked in each `case` arm below. Worse, the
ICMP entries in transportProtocolMinSizes are incorrect, and produce false "raw
packet" logs.
PiperOrigin-RevId: 315730073
|
|
|
|
PiperOrigin-RevId: 315711208
|
|
|
