Age | Commit message (Collapse) | Author |
|
On Linux these are meant to be equivalent to POLLIN/POLLOUT. Rather
than hack these on in sys_poll etc it felt cleaner to just cleanup
the call sites to notify for both events. This is what linux does
as well.
Fixes #5544
PiperOrigin-RevId: 364859977
|
|
PiperOrigin-RevId: 364859173
|
|
This change sets the inner `routeInfo` struct to be a named private member
and replaces direct access with access through getters. Note that direct
access to the fields of `routeInfo` is still possible through the `RouteInfo`
struct.
Fixes #4902
PiperOrigin-RevId: 364822872
|
|
PiperOrigin-RevId: 364596526
|
|
...instead of opting out of them.
Loopback traffic should be stack-local but gVisor has some clients
that depend on the ability to receive loopback traffic that originated
from outside of the stack. Because of this, we guard this change behind
IP protocol options.
A previous change provided the facility to deny these martian loopback
packets but this change requires client to opt-in to accepting martian
loopback packets as accepting martian loopback packets are not meant
to be accepted, as per RFC 1122 section 3.2.1.3.g:
(g) { 127, <any> }
Internal host loopback address. Addresses of this form
MUST NOT appear outside a host.
PiperOrigin-RevId: 364581174
|
|
PiperOrigin-RevId: 364381970
|
|
Transport demuxer and UDP tests should not use a loopback address as the
source address for packets injected into the stack as martian loopback
packets will be dropped in a later change.
PiperOrigin-RevId: 363479681
|
|
Loopback traffic should be stack-local but gVisor has some clients
that depend on the ability to receive loopback traffic that originated
from outside of the stack. Because of this, we guard this change behind
IP protocol options.
Test: integration_test.TestExternalLoopbackTraffic
PiperOrigin-RevId: 363461242
|
|
Netstack does not check ACK number for FIN-ACK packets and goes into TIMEWAIT
unconditionally. Fixing the state machine will give us back the retransmission
of FIN.
PiperOrigin-RevId: 363301883
|
|
There is a race in handling new incoming connections on a listening
endpoint that causes the endpoint to reply to more incoming SYNs than
what is permitted by the listen backlog.
The race occurs when there is a successful passive connection handshake
and the synRcvdCount counter is decremented, followed by the endpoint
delivered to the accept queue. In the window of time between
synRcvdCount decrementing and the endpoint being enqueued for accept,
new incoming SYNs can be handled without honoring the listen backlog
value, as the backlog could be perceived not full.
Fixes #5637
PiperOrigin-RevId: 363279372
|
|
They are not used outside of the header package.
PiperOrigin-RevId: 363237708
|
|
...as per RFC 7527.
If a looped-back DAD message is received, do not fail DAD since our own
DAD message does not indicate that a neighbor has the address assigned.
Test: ndp_test.TestDADResolveLoopback
PiperOrigin-RevId: 363224288
|
|
Calling into the stack from LinkAddressRequest is not needed as we
already have a reference to the network endpoint (IPv6) or network
interface (IPv4/ARP).
PiperOrigin-RevId: 363213973
|
|
Doing so involved breaking dependencies between //pkg/tcpip and the rest
of gVisor, which are discouraged anyways.
Tested on the Go branch via:
gvisor.dev/gvisor/pkg/tcpip/...
Addresses #1446.
PiperOrigin-RevId: 363081778
|
|
Lots of small changes:
- simplify package API via Reservation type
- rename some single-letter variable names that were hard to follow
- rename some types
PiperOrigin-RevId: 362442366
|
|
- Implement Stringer for it so that we can improve error messages.
- Use TCPFlags through the code base. There used to be a mixed usage of byte,
uint8 and int as TCP flags.
PiperOrigin-RevId: 361940150
|
|
Speeds up the socket stress tests by a couple orders of magnitude.
PiperOrigin-RevId: 361721050
|
|
Updates #5597
PiperOrigin-RevId: 361252003
|
|
IPv4 would violate the lock ordering of protocol > endpoint when closing
network endpoints by calling `ipv4.protocol.forgetEndpoint` while
holding the network endpoint lock.
PiperOrigin-RevId: 361232817
|
|
The integrator may be interested in who owns a duplicate address so
pass this information (if available) along.
Fixes #5605.
PiperOrigin-RevId: 361213556
|
|
While I'm here, update NDPDispatcher.OnDuplicateAddressDetectionStatus to
take a DADResult and rename it to OnDuplicateAddressDetectionResult.
Fixes #5606.
PiperOrigin-RevId: 360965416
|
|
The only user is in (*handshake).complete and it specifies MaxRTO, so there is
no behavior changes.
PiperOrigin-RevId: 360954447
|
|
clientEP.Connect may fail because serverEP was not listening.
PiperOrigin-RevId: 360780667
|
|
One of the preparation to decouple underlying buffer implementation.
There are still some methods that tie to VectorisedView, and they will be
changed gradually in later CLs.
This CL also introduce a new ICMPv6ChecksumParams to replace long list of
parameters when calling ICMPv6Checksum, aiming to be more descriptive.
PiperOrigin-RevId: 360778149
|
|
Changes the neighbor_cache_test.go tests to always assert UpdatedAtNanos.
Completes the assertion of UpdatedAtNanos in every NUD test, a field that was
historically not checked due to the lack of a deterministic, controllable
clock. This is no longer true with the tcpip.Clock interface. While the tests
have been adjusted to use Clock, asserting by the UpdatedAtNanos was neglected.
Fixes #4663
PiperOrigin-RevId: 360730077
|
|
This validates that struct fields if annotated with "// checklocks:mu" where
"mu" is a mutex field in the same struct then access to the field is only
done with "mu" locked.
All types that are guarded by a mutex must be annotated with
// +checklocks:<mutex field name>
For more details please refer to README.md.
PiperOrigin-RevId: 360729328
|
|
While I'm here, simplify the comments and unify naming of certain stats
across protocols.
PiperOrigin-RevId: 360728849
|
|
The syscall package has been deprecated in favor of golang.org/x/sys.
Note that syscall is still used in the following places:
- pkg/sentry/socket/hostinet/stack.go: some netlink related functionalities
are not yet available in golang.org/x/sys.
- syscall.Stat_t is still used in some places because os.FileInfo.Sys() still
returns it and not unix.Stat_t.
Updates #214
PiperOrigin-RevId: 360701387
|
|
Prevent the situation where callers to (*stack).GetLinkAddress provide
incorrect arguments and are unable to observe this condition.
Updates #5583.
PiperOrigin-RevId: 360481557
|
|
io.Reader.ReadFull returns the number of bytes copied and an error if fewer
bytes were read.
PiperOrigin-RevId: 360247614
|
|
There is a short race where in Write an endpoint can transition from writable
to non-writable state due to say an incoming RST during the time we release
the endpoint lock and reacquire after copying the payload. In such a case
if the write happens to be a zero sized write we end up trying to call
sendData() even though nothing was queued.
This can panic when trying to enable/disable TCP timers if the endpoint had
already transitioned to a CLOSED/ERROR state due to the incoming RST as we
cleanup timers when the protocol goroutine terminates.
Sadly the race window is small enough that my attempts at reproducing the panic
in a syscall test has not been successful.
PiperOrigin-RevId: 359887905
|
|
Changes the neighbor_entry_test.go tests to always assert UpdatedAtNanos.
This field was historically not checked due to the lack of a deterministic,
controllable clock. This is no longer true with the tcpip.Clock interface.
While the tests have been adjusted to use Clock, asserting by the
UpdatedAtNanos was neglected.
Subsequent work is needed to assert UpdatedAtNanos in the neighbor cache tests.
Updates #4663
PiperOrigin-RevId: 359868254
|
|
Converts entryTestLinkResolver and testNUDDispatcher to use the embedded
sync.Mutex pattern for fields that may be accessed concurrently from different
gorountines.
Fixes #5541
PiperOrigin-RevId: 359826169
|
|
Adds helper functions for transitioning into common states. This reduces the
boilerplate by a fair amount, decreasing the barriers to entry for new features
added to neighborEntry.
PiperOrigin-RevId: 359810465
|
|
Also increase refcount of raw.endpoint.route while in use.
Avoid allocating an array of size zero.
PiperOrigin-RevId: 359797788
|
|
Use maybeSendSegment while sending segments in RACK recovery which checks if
the receiver has space and splits the segments when the segment size is
greater than MSS.
PiperOrigin-RevId: 359641097
|
|
Prevents the following deadlock:
- Raw packet is sent via e.Write(), which read locks e.mu
- Connect() is called, blocking on write locking e.mu
- The packet is routed to loopback and back to e.HandlePacket(), which read
locks e.mu
Per the atomic.RWMutex documentation, this deadlocks:
"If a goroutine holds a RWMutex for reading and another goroutine might call
Lock, no goroutine should expect to be able to acquire a read lock until the
initial read lock is released. In particular, this prohibits recursive read
locking. This is to ensure that the lock eventually becomes available; a blocked
Lock call excludes new readers from acquiring the lock."
Also, release eps.mu earlier in deliverRawPacket.
PiperOrigin-RevId: 359600926
|
|
Fixes #5490
PiperOrigin-RevId: 359401532
|
|
Previously, when DAD would detect a conflict for a temporary address,
the address would be removed but its timers would not be stopped,
resulting in a panic when the removed address's invalidation timer
fired.
While I'm here, remove the check for unicast-ness on removed address
endpoints since multicast addresses are no longer stored in the same
structure as unicast addresses as of 27ee4fe76ad586ac8751951a842b3681f93.
Test: stack_test.TestMixedSLAACAddrConflictRegen
PiperOrigin-RevId: 359344849
|
|
- Use atomic add rather than CAS in every Gate method, which is slightly
faster in most cases.
- Implement Close wakeup using gopark/goready to avoid channel allocation.
New benchmarks:
name old time/op new time/op delta
GateEnterLeave-12 16.7ns ± 1% 10.3ns ± 1% -38.44% (p=0.000 n=9+8)
GateClose-12 50.2ns ± 8% 42.4ns ± 6% -15.44% (p=0.000 n=10+10)
GateEnterLeaveAsyncClose-12 972ns ± 2% 640ns ± 7% -34.15% (p=0.000 n=9+10)
PiperOrigin-RevId: 359336344
|
|
These are bumped to allow early testing of Go 1.17. Use will be audited closer
to the 1.17 release.
PiperOrigin-RevId: 358278615
|
|
This change also adds support for Router Alert option processing on
incoming packets, a new stat for Router Alert option, and exports
all the IP-option related stats.
Fixes #5491
PiperOrigin-RevId: 358238123
|
|
Completes the soft migration to Unreachable state by removing the Failed state
and the the FailedEntryLookups StatCounter.
Fixes #4667
PiperOrigin-RevId: 358226380
|
|
PiperOrigin-RevId: 358078157
|
|
tcpip integration tests have been flaky lately. They usually run in 20 seconds
and have a 60 seconds timeout. Sometimes they timeout which could be due to
a bug or deadlock. To further investigate it might be helpful to split the
targets and see which test is causing the flake.
Added a new tcpip/tests/utils package to hold all common utilities across all
tests.
PiperOrigin-RevId: 358012936
|
|
This change implements TLP details enumerated in
https://tools.ietf.org/html/draft-ietf-tcpm-rack-08#section-7.5.3
Fixes #5085
PiperOrigin-RevId: 357125037
|
|
Entry check:
- Earlier implementation was preventing us from entering recovery even if
SND.UNA is lost but dupAckCount is still below threshold. Fixed that.
- We should only enter recovery when at least one more byte of data beyond the
highest byte that was outstanding when fast retransmit was last entered is
acked. Added that check.
Exit check:
- Earlier we were checking if SEG.ACK is in range [SND.UNA, SND.NXT]. The
intention was to check if any unacknowledged data was ACKed. Note that
(SEG.ACK - 1) is actually the sequence number which was ACKed. So we were
incorrectly including (SND.UNA - 1) in the range. Fixed the check to now be
(SEG.ACK - 1) in range [SND.UNA, SND.NXT).
Additionally, moved a RACK specific test to the rack tests file.
Added tests for the changes I made.
PiperOrigin-RevId: 357091322
|
|
Added a LINT IfChange/ThenChange check to catch this in the future.
PiperOrigin-RevId: 357077564
|
|
TestRACKWithDuplicateACK is flaky as the reorder window can expire before
receiving three duplicate ACKs which will result in sending the first
unacknowledged segment twice: when reorder timer expired and again after
receiving the third duplicate ACK.
This CL will fix this behavior and will not resend the segment again if it was
already re-transmittted when reorder timer expired.
Update the TestRACKWithDuplicateACK to test that the first segment is
considered as lost and is re-transmitted.
PiperOrigin-RevId: 356855168
|
|
PiperOrigin-RevId: 356852625
|