Age | Commit message (Collapse) | Author |
|
|
|
Tests: stack_test.TestAttachToLinkEndpointImmediately
PiperOrigin-RevId: 296474068
|
|
|
|
Test: stack_test.TestRouterSolicitation
PiperOrigin-RevId: 296454766
|
|
|
|
- Disabled NICs will have their associated NDP state cleared.
- Disabled NICs will not accept incoming packets.
- Writes through a Route with a disabled NIC will return an invalid
endpoint state error.
- stack.Stack.FindRoute will not return a route with a disabled NIC.
- NIC's Running flag will report the NIC's enabled status.
Tests:
- stack_test.TestDisableUnknownNIC
- stack_test.TestDisabledNICsNICInfoAndCheckNIC
- stack_test.TestRoutesWithDisabledNIC
- stack_test.TestRouteWritePacketWithDisabledNIC
- stack_test.TestStopStartSolicitingRouters
- stack_test.TestCleanupNDPState
- stack_test.TestAddRemoveIPv4BroadcastAddressOnNICEnableDisable
- stack_test.TestJoinLeaveAllNodesMulticastOnNICEnableDisable
PiperOrigin-RevId: 296298588
|
|
|
|
|
|
|
|
PiperOrigin-RevId: 294500858
|
|
|
|
|
|
Previously, a DAD event would not be sent if DAD was disabled.
This allows integrators to do some work when an IPv6 address is bound to
a NIC without special logic that checks if DAD is enabled.
Without this change, integrators would need to check if a NIC has DAD
enabled when an address is auto-generated. If DAD is enabled, it would
need to delay the work until the DAD completion event; otherwise, it
would need to do the work in the address auto-generated event handler.
Test: stack_test.TestDADDisabled
PiperOrigin-RevId: 293732914
|
|
|
|
Auto-generated link-local addresses should have the same lifecycle hooks
as global SLAAC addresses.
The Stack's NDP dispatcher should be notified when link-local addresses
are auto-generated and invalidated. They should also be removed when a
NIC is disabled (which will be supported in a later change).
Tests:
- stack_test.TestNICAutoGenAddrWithOpaque
- stack_test.TestNICAutoGenAddr
PiperOrigin-RevId: 293706760
|
|
|
|
Addresses may be added before a NIC is enabled. Make sure DAD is
performed on the permanent IPv6 addresses when they get enabled.
Test:
- stack_test.TestDoDADWhenNICEnabled
- stack.TestDisabledRxStatsWhenNICDisabled
PiperOrigin-RevId: 293697429
|
|
Get the link address for the target of an NDP Neighbor Advertisement
from the NDP Target Link Layer Address option.
Tests:
- ipv6.TestNeighorAdvertisementWithTargetLinkLayerOption
- ipv6.TestNeighorAdvertisementWithInvalidTargetLinkLayerOption
PiperOrigin-RevId: 293632609
|
|
|
|
PiperOrigin-RevId: 293271055
|
|
|
|
As per RFC 2464 section 7, an IPv6 packet with a multicast destination
address is transmitted to the mapped Ethernet multicast address.
Test:
- ipv6.TestLinkResolution
- stack_test.TestDADResolve
- stack_test.TestRouterSolicitation
PiperOrigin-RevId: 292610529
|
|
|
|
When sending NDP messages with an unspecified source address, the Source
Link Layer address must not be included.
Test: stack_test.TestDADResolve
PiperOrigin-RevId: 292341334
|
|
|
|
Do not start a new goroutine when calling
stack.NDPDispatcher.OnDuplicateAddressDetectionStatus.
PiperOrigin-RevId: 292268574
|
|
|
|
Test: stack_test.TestDADResolve
PiperOrigin-RevId: 292003124
|
|
This is to aid later implementation for /dev/net/tun device.
PiperOrigin-RevId: 291746025
|
|
PiperOrigin-RevId: 291745021
|
|
|
|
PiperOrigin-RevId: 291426657
|
|
Increase the timeout to 1s when waiting for async NDP events to help
reduce flakiness. This will not significantly increase test times as the
async events continue to receive an event on a channel. The increased
timeout allows more time for an event to be sent on the channel as the
previous timeout of 100ms caused some flakes.
Test: Existing tests pass
PiperOrigin-RevId: 291420936
|
|
|
|
- Wrap NIC's fields that should only be accessed while holding the mutex in
an anonymous struct with the embedded mutex.
- Make sure NIC's spoofing and promiscuous mode flags are only read while
holding the NIC's mutex.
- Use the correct endpoint when sending DAD messages.
- Do not hold the NIC's lock when sending DAD messages.
This change does not introduce any behaviour changes.
Tests: Existing tests continue to pass.
PiperOrigin-RevId: 291036251
|
|
|
|
PiperOrigin-RevId: 290793754
|
|
|
|
CERT Advisory CA-96.21 III. Solution advises that devices drop packets which
could not have correctly arrived on the wire, such as receiving a packet where
the source IP address is owned by the device that sent it.
Fixes #1507
PiperOrigin-RevId: 290378240
|
|
|
|
It was possible to use this function incorrectly, and its separation
wasn't buying us anything.
PiperOrigin-RevId: 290311100
|
|
|
|
If a previously added IPv6 address (statically or via SLAAC) was removed, it
would be left in an expired state waiting to be cleaned up if any references to
it were still held. During this time, the same address could be regenerated via
SLAAC, which should be allowed. This change supports this scenario.
When upgrading an endpoint from temporary or permanentExpired to permanent,
respect the new configuration type (static or SLAAC) and deprecated status,
along with the new PrimaryEndpointBehavior (which was already supported).
Test: stack.TestAutoGenAddrAfterRemoval
PiperOrigin-RevId: 289990168
|
|
|
|
This change adds support to send NDP Router Solicitation messages when a NIC
becomes enabled as a host, as per RFC 4861 section 6.3.7.
Note, Router Solicitations will only be sent when the stack has forwarding
disabled.
Tests: Unittests to make sure that the initial Router Solicitations are sent
as configured. The tests also validate the sent Router Solicitations' fields.
PiperOrigin-RevId: 289964095
|
|
|
|
All inbound segments for connections in ESTABLISHED state are delivered to the
endpoint's queue but for every segment delivered we also queue the endpoint for
processing to a selected processor. This ensures that when there are a large
number of connections in ESTABLISHED state the inbound packets are all handled
by a small number of goroutines and significantly reduces the amount of work the
goscheduler has to perform.
We let connections in other states follow the current path where the
endpoint's goroutine directly handles the segments.
Updates #231
PiperOrigin-RevId: 289728325
|
|
|
|
PiperOrigin-RevId: 289718534
|
|
|