| Age | Commit message (Collapse) | Author |
|---|
|
|
|
When VectorisedViews were passed up the stack from packet_dispatchers, we were
passing a sub-slice of the dispatcher's views fields. The dispatchers then
immediately set those views to nil.
This wasn't caught before because every implementer copied the data in these
views before returning.
PiperOrigin-RevId: 277615351
|
|
|
|
It is required to guarantee the same order of endpoints after save/restore.
PiperOrigin-RevId: 277598665
|
|
|
|
Link endpoints still don't have a unified way to be requested to stop.
Updates #837
PiperOrigin-RevId: 277398952
|
|
|
|
In the future this will replace DanglingEndpoints. DanglingEndpoints must be
kept for now due to issues with save/restore.
This is arguably a cleaner design and allows the stack to know which transport
endpoints might still be using its link endpoints.
Updates #837
PiperOrigin-RevId: 277386633
|
|
|
|
Updates #837
PiperOrigin-RevId: 277325162
|
|
|
|
This change supports using a user supplied TCP MSS for new active TCP
connections. Note, the user supplied MSS must be less than or equal to the
maximum possible MSS for a TCP connection's route. If it is greater than the
maximum possible MSS, the maximum possible MSS will be used as the connection's
MSS instead.
This change does not use this user supplied MSS for connections accepted from
listening sockets - that will come in a later change.
Test: Test that outgoing TCP SYN segments contain a TCP MSS option with the user
supplied MSS if it is not greater than the maximum possible MSS for the route.
PiperOrigin-RevId: 277185125
|
|
|
|
This change makes it so that NDP work is done using the per-interface NDP
configurations instead of the stack-wide default NDP configurations to correctly
implement RFC 4861 section 6.3.2 (note here, a host is a single NIC operating
as a host device), and RFC 4862 section 5.1.
Test: Test that we can set NDP configurations on a per-interface basis without
affecting the configurations of other interfaces or the stack-wide default. Also
make sure that after the configurations are updated, the updated configurations
are used for NDP processes (e.g. Duplicate Address Detection).
PiperOrigin-RevId: 276525661
|
|
|
|
This change introduces a new interface, stack.NDPDispatcher. It can be
implemented by the netstack integrator to receive NDP related events. As of this
change, only DAD related events are supported.
Tests: Existing tests were modified to use the NDPDispatcher's DAD events for
DAD tests where it needed to wait for DAD completing (failing and resolving).
PiperOrigin-RevId: 276338733
|
|
|
|
This change makes sure that when an address which is already known by a NIC and
has kind = permanentExpired gets promoted to permanent, the new
PrimaryEndpointBehavior is respected.
PiperOrigin-RevId: 276136317
|
|
|
|
Right now, we send each tcp packet separately, we call one system
call per-packet. This patch allows to generate multiple tcp packets
and send them by sendmmsg.
The arguable part of this CL is a way how to handle multiple headers.
This CL adds the next field to the Prepandable buffer.
Nginx test results:
Server Software: nginx/1.15.9
Server Hostname: 10.138.0.2
Server Port: 8080
Document Path: /10m.txt
Document Length: 10485760 bytes
w/o gso:
Concurrency Level: 5
Time taken for tests: 5.491 seconds
Complete requests: 100
Failed requests: 0
Total transferred: 1048600200 bytes
HTML transferred: 1048576000 bytes
Requests per second: 18.21 [#/sec] (mean)
Time per request: 274.525 [ms] (mean)
Time per request: 54.905 [ms] (mean, across all concurrent requests)
Transfer rate: 186508.03 [Kbytes/sec] received
sw-gso:
Concurrency Level: 5
Time taken for tests: 3.852 seconds
Complete requests: 100
Failed requests: 0
Total transferred: 1048600200 bytes
HTML transferred: 1048576000 bytes
Requests per second: 25.96 [#/sec] (mean)
Time per request: 192.576 [ms] (mean)
Time per request: 38.515 [ms] (mean, across all concurrent requests)
Transfer rate: 265874.92 [Kbytes/sec] received
w/o gso:
$ ./tcp_benchmark --client --duration 15 --ideal
[SUM] 0.0-15.1 sec 2.20 GBytes 1.25 Gbits/sec
software gso:
$ tcp_benchmark --client --duration 15 --ideal --gso $((1<<16)) --swgso
[SUM] 0.0-15.1 sec 3.99 GBytes 2.26 Gbits/sec
PiperOrigin-RevId: 276112677
|
|
|
|
This change adds support for optionally auto-generating an IPv6 link-local
address based on the NIC's MAC Address on NIC enable.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that a link-local
address will not be auto-generated unless the stack is explicitly configured.
See `stack.Options` for more details. Specifically, see
`stack.Options.AutoGenIPv6LinkLocal`.
Tests: Tests to make sure that the IPb6 link-local address is only
auto-generated if the stack is specifically configured to do so. Also tests to
make sure that an auto-generated address goes through the DAD process.
PiperOrigin-RevId: 276059813
|
|
|
|
Like (AF_INET, SOCK_RAW) sockets, AF_PACKET sockets require CAP_NET_RAW. With
runsc, you'll need to pass `--net-raw=true` to enable them.
Binding isn't supported yet.
PiperOrigin-RevId: 275909366
|
|
|
|
There's no need for a linked list here.
PiperOrigin-RevId: 275565920
|
|
|
|
It is quite legal to send from the ANY address (it is required for
DHCP). I can't figure out why the broadcast address was included here,
so removing that as well.
PiperOrigin-RevId: 275541954
|
|
|
|
NDP Neighbor Solicitations sent during Duplicate Address Detection must have an
IP hop limit of 255, as all NDP Neighbor Solicitations should have.
Test: Test that DAD messages have the IPv6 hop limit field set to 255.
PiperOrigin-RevId: 275321680
|
|
|
|
This change adds support for Duplicate Address Detection on IPv6 addresses
as defined by RFC 4862 section 5.4.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that DAD will not be
performed. See `stack.Options` and `stack.NDPConfigurations` for more details.
Tests: Tests to make sure that the DAD process properly resolves or fails.
That is, tests make sure that DAD resolves only if:
- No other node is performing DAD for the same address
- No other node owns the same address
PiperOrigin-RevId: 275189471
|
|
|
|
...and do not populate link address cache at dispatch. This partially
reverts 313c767b0001bf6271405f1b765b60a334d6e911, which caused malformed
packets (e.g. NDP Neighbor Adverts with incorrect hop limit values) to
populate the address cache. In particular, this masked a bug that was
introduced to the Neighbor Advert generation code in
7c1587e3401a010d1865df61dbaf117c77dd062e.
PiperOrigin-RevId: 274865182
|
|
|
|
PiperOrigin-RevId: 274700093
|
|
PiperOrigin-RevId: 274672346
|
|
|
|
PiperOrigin-RevId: 273861936
|
|
|
|
Also change the default TTL to 64 to match Linux.
PiperOrigin-RevId: 273430341
|
|
|
|
The behavior for sending and receiving local broadcast (255.255.255.255)
traffic is as follows:
Outgoing
--------
* A broadcast packet sent on a socket that is bound to an interface goes out
that interface
* A broadcast packet sent on an unbound socket follows the route table to
select the outgoing interface
+ if an explicit route entry exists for 255.255.255.255/32, use that one
+ else use the default route
* Broadcast packets are looped back and delivered following the rules for
incoming packets (see next). This is the same behavior as for multicast
packets, except that it cannot be disabled via sockopt.
Incoming
--------
* Sockets wishing to receive broadcast packets must bind to either INADDR_ANY
(0.0.0.0) or INADDR_BROADCAST (255.255.255.255). No other socket receives
broadcast packets.
* Broadcast packets are multiplexed to all sockets matching it. This is the
same behavior as for multicast packets.
* A socket can bind to 255.255.255.255:<port> and then receive its own
broadcast packets sent to 255.255.255.255:<port>
In addition, this change implicitly fixes an issue with multicast reception. If
two sockets want to receive a given multicast stream and one is bound to ANY
while the other is bound to the multicast address, only one of them will
receive the traffic.
PiperOrigin-RevId: 272792377
|
|
|
|
Netstack always picks a random start point everytime PickEphemeralPort
is called. While this is required for UDP so that DNS requests go
out through a randomized set of ports it is not required for TCP. Infact
Linux explicitly hashes the (srcip, dstip, dstport) and a one time secret
initialized at start of the application to get a random offset. But to
ensure it doesn't start from the same point on every scan it uses a static
hint that is incremented by 2 in every call to pick ephemeral ports.
The reason for 2 is Linux seems to split the port ranges where active connects
seem to use even ones while odd ones are used by listening sockets.
This CL implements a similar strategy where we use a hash + hint to generate
the offset to start the search for a free Ephemeral port.
This ensures that we cycle through the available port space in order for
repeated connects to the same destination and significantly reduces the
chance of picking a recently released port.
PiperOrigin-RevId: 272058370
|
|
|
|
PiperOrigin-RevId: 271644926
|
|
|
|
Also removes the need for protocol names.
PiperOrigin-RevId: 271186030
|
|
|
