Age | Commit message (Collapse) | Author |
|
Enables commands with -o (--out-interface) for iptables rules.
$ iptables -A OUTPUT -o eth0 -j ACCEPT
PiperOrigin-RevId: 310642286
|
|
Connection tracking is used to track packets in prerouting and
output hooks of iptables. The NAT rules modify the tuples in
connections. The connection tracking code modifies the packets by
looking at the modified tuples.
|
|
PiperOrigin-RevId: 309491861
|
|
Implement rule 7 of Source Address Selection RFC 6724 section 5. This
makes temporary (short-lived) addresses preferred over non-temporary
addresses when earlier rules are equal.
Test: stack_test.TestIPv6SourceAddressSelectionScopeAndSameAddress
PiperOrigin-RevId: 309250975
|
|
Support generating temporary (short-lived) IPv6 SLAAC addresses to
address privacy concerns outlined in RFC 4941.
Tests:
- stack_test.TestAutoGenTempAddr
- stack_test.TestNoAutoGenTempAddrForLinkLocal
- stack_test.TestAutoGenTempAddrRegen
- stack_test.TestAutoGenTempAddrRegenTimerUpdates
- stack_test.TestNoAutoGenTempAddrWithoutStableAddr
- stack_test.TestAutoGenAddrInResponseToDADConflicts
PiperOrigin-RevId: 308915566
|
|
PiperOrigin-RevId: 308674219
|
|
These methods let users eaily break the VectorisedView abstraction, and
allowed netstack to slip into pseudo-enforcement of the "all headers are
in the first View" invariant. Removing them and replacing with PullUp(n)
breaks this reliance and will make it easier to add iptables support and
rework network buffer management.
The new View.PullUp(n) method is low cost in the common case, when when
all the headers fit in the first View.
PiperOrigin-RevId: 308163542
|
|
PiperOrigin-RevId: 307598974
|
|
These methods let users eaily break the VectorisedView abstraction, and
allowed netstack to slip into pseudo-enforcement of the "all headers are
in the first View" invariant. Removing them and replacing with PullUp(n)
breaks this reliance and will make it easier to add iptables support and
rework network buffer management.
The new View.PullUp(n) method is low cost in the common case, when when
all the headers fit in the first View.
|
|
As per RFC 7217 section 6, attempt to regenerate IPv6 SLAAC address in response
to a DAD conflict if the address was generated with an opaque IID as outlined in
RFC 7217 section 5.
Test:
- stack_test.TestAutoGenAddrWithOpaqueIIDDADRetries
- stack_test.TestAutoGenAddrWithEUI64IIDNoDADRetries
- stack_test.TestAutoGenAddrContinuesLifetimesAfterRetry
PiperOrigin-RevId: 306555645
|
|
PiperOrigin-RevId: 303212189
|
|
This is a precursor to be being able to build an intrusive list
of PacketBuffers for use in queuing disciplines being implemented.
Updates #2214
PiperOrigin-RevId: 302677662
|
|
Previously, SLAAC related state was stored on a per-address basis. This was
sufficient for the simple case of a single SLAAC address per prefix, but
future CLs will introduce temporary addresses which will result in multiple
SLAAC addresses for a prefix. This refactor allows storing multiple addresses
for a prefix in a single SLAAC prefix state.
No behaviour changes - existing tests continue to pass.
PiperOrigin-RevId: 300832812
|
|
When a NIC is removed, attempt to disable the NIC first to cleanup
dynamic state and stop ongoing periodic tasks (e.g. IPv6 router
solicitations, DAD) so that a removed NIC does not attempt to send
packets.
Tests:
- stack_test.TestRemoveUnknownNIC
- stack_test.TestRemoveNIC
- stack_test.TestDADStop
- stack_test.TestCleanupNDPState
- stack_test.TestRouteWithDownNIC
- stack_test.TestStopStartSolicitingRouters
PiperOrigin-RevId: 300805857
|
|
LinkEndpoints may expect/assume that the a tcpip.PacketBuffer's Header
has enough capacity for its own headers, as per documentation for
LinkEndpoint.MaxHeaderLength.
Test: stack_test.TestNICForwarding
PiperOrigin-RevId: 300784192
|
|
PiperOrigin-RevId: 300362789
|
|
PiperOrigin-RevId: 300308974
|
|
This change also updates where the IP packet buffer is held in an
outbound tcpip.PacketBuffer from Header to Data. This change removes
unncessary copying of the IP packet buffer when forwarding.
Test: stack_test.TestNICForwarding
PiperOrigin-RevId: 300217972
|
|
Fixes #1510
Test:
- stack_test.TestForwardingWithStaticResolver
- stack_test.TestForwardingWithFakeResolver
- stack_test.TestForwardingWithNoResolver
- stack_test.TestForwardingWithFakeResolverPartialTimeout
- stack_test.TestForwardingWithFakeResolverTwoPackets
- stack_test.TestForwardingWithFakeResolverManyPackets
- stack_test.TestForwardingWithFakeResolverManyResolutions
PiperOrigin-RevId: 300182570
|
|
A deadlock may occur if a write lock on a RWMutex is blocked between
nested read lock attempts as the inner read lock attempt will be
blocked in this scenario.
Example (T1 and T2 are differnt goroutines):
T1: obtain read-lock
T2: attempt write-lock (blocks)
T1: attempt inner/nested read-lock (blocks)
Here we can see that T1 and T2 are deadlocked.
Tests: Existing tests pass.
PiperOrigin-RevId: 298426678
|
|
|
|
- commit the changes for the comments.
|
|
PiperOrigin-RevId: 296526279
|
|
Tests: stack_test.TestAttachToLinkEndpointImmediately
PiperOrigin-RevId: 296474068
|
|
- Disabled NICs will have their associated NDP state cleared.
- Disabled NICs will not accept incoming packets.
- Writes through a Route with a disabled NIC will return an invalid
endpoint state error.
- stack.Stack.FindRoute will not return a route with a disabled NIC.
- NIC's Running flag will report the NIC's enabled status.
Tests:
- stack_test.TestDisableUnknownNIC
- stack_test.TestDisabledNICsNICInfoAndCheckNIC
- stack_test.TestRoutesWithDisabledNIC
- stack_test.TestRouteWritePacketWithDisabledNIC
- stack_test.TestStopStartSolicitingRouters
- stack_test.TestCleanupNDPState
- stack_test.TestAddRemoveIPv4BroadcastAddressOnNICEnableDisable
- stack_test.TestJoinLeaveAllNodesMulticastOnNICEnableDisable
PiperOrigin-RevId: 296298588
|
|
Add nat table support for Prerouting hook with Redirect option.
Add tests to check redirect of ports.
|
|
PiperOrigin-RevId: 294500858
|
|
Auto-generated link-local addresses should have the same lifecycle hooks
as global SLAAC addresses.
The Stack's NDP dispatcher should be notified when link-local addresses
are auto-generated and invalidated. They should also be removed when a
NIC is disabled (which will be supported in a later change).
Tests:
- stack_test.TestNICAutoGenAddrWithOpaque
- stack_test.TestNICAutoGenAddr
PiperOrigin-RevId: 293706760
|
|
Addresses may be added before a NIC is enabled. Make sure DAD is
performed on the permanent IPv6 addresses when they get enabled.
Test:
- stack_test.TestDoDADWhenNICEnabled
- stack.TestDisabledRxStatsWhenNICDisabled
PiperOrigin-RevId: 293697429
|
|
PiperOrigin-RevId: 291426657
|
|
- Wrap NIC's fields that should only be accessed while holding the mutex in
an anonymous struct with the embedded mutex.
- Make sure NIC's spoofing and promiscuous mode flags are only read while
holding the NIC's mutex.
- Use the correct endpoint when sending DAD messages.
- Do not hold the NIC's lock when sending DAD messages.
This change does not introduce any behaviour changes.
Tests: Existing tests continue to pass.
PiperOrigin-RevId: 291036251
|
|
PiperOrigin-RevId: 290793754
|
|
CERT Advisory CA-96.21 III. Solution advises that devices drop packets which
could not have correctly arrived on the wire, such as receiving a packet where
the source IP address is owned by the device that sent it.
Fixes #1507
PiperOrigin-RevId: 290378240
|
|
It was possible to use this function incorrectly, and its separation
wasn't buying us anything.
PiperOrigin-RevId: 290311100
|
|
If a previously added IPv6 address (statically or via SLAAC) was removed, it
would be left in an expired state waiting to be cleaned up if any references to
it were still held. During this time, the same address could be regenerated via
SLAAC, which should be allowed. This change supports this scenario.
When upgrading an endpoint from temporary or permanentExpired to permanent,
respect the new configuration type (static or SLAAC) and deprecated status,
along with the new PrimaryEndpointBehavior (which was already supported).
Test: stack.TestAutoGenAddrAfterRemoval
PiperOrigin-RevId: 289990168
|
|
This change adds support to send NDP Router Solicitation messages when a NIC
becomes enabled as a host, as per RFC 4861 section 6.3.7.
Note, Router Solicitations will only be sent when the stack has forwarding
disabled.
Tests: Unittests to make sure that the initial Router Solicitations are sent
as configured. The tests also validate the sent Router Solicitations' fields.
PiperOrigin-RevId: 289964095
|
|
PiperOrigin-RevId: 289718534
|
|
Do Source Address Selection when choosing an IPv6 source address as per RFC 6724
section 5 rules 1-3:
1) Prefer same address
2) Prefer appropriate scope
3) Avoid deprecated addresses.
A later change will update Source Address Selection to follow rules 4-8.
Tests:
Rule 1 & 2: stack.TestIPv6SourceAddressSelectionScopeAndSameAddress,
Rule 3: stack.TestAutoGenAddrTimerDeprecation,
stack.TestAutoGenAddrDeprecateFromPI
PiperOrigin-RevId: 289559373
|
|
|
|
* Rename syncutil to sync.
* Add aliases to sync types.
* Replace existing usage of standard library sync package.
This will make it easier to swap out synchronization primitives. For example,
this will allow us to use primitives from github.com/sasha-s/go-deadlock to
check for lock ordering violations.
Updates #1472
PiperOrigin-RevId: 289033387
|
|
...retrievable later via stack.NICInfo().
Clients of this library can use it to add metadata that should be tracked
alongside a NIC, to avoid having to keep a map[tcpip.NICID]metadata mirroring
stack.Stack's nic map.
PiperOrigin-RevId: 288924900
|
|
ending up with the wrong chains and is indexing -1 into rules.
|
|
...enabling us to remove the "CreateNamedLoopbackNIC" variant of
CreateNIC and all the plumbing to connect it through to where the value
is read in FindRoute.
PiperOrigin-RevId: 288713093
|
|
Support deprecating network endpoints on a NIC. If an endpoint is deprecated, it
should not be used for new connections unless a more preferred endpoint is not
available, or unless the deprecated endpoint was explicitly requested.
Test: Test that deprecated endpoints are only returned when more preferred
endpoints are not available and SLAAC addresses are deprecated after its
preferred lifetime
PiperOrigin-RevId: 288562705
|
|
Test: Test that an IPv6 link-local address is not auto-generated for loopback
NICs, even when it is enabled for non-loopback NICS.
PiperOrigin-RevId: 288519591
|
|
Pass the NIC-internal name to the NIC name function when generating opaque IIDs
so implementations can use the name that was provided when the NIC was created.
Previously, explicit NICID to NIC name resolution was required from the netstack
integrator.
Tests: Test that the name provided when creating a NIC is passed to the NIC name
function when generating opaque IIDs.
PiperOrigin-RevId: 288395359
|
|
Support generating opaque interface identifiers as defined by RFC 7217 for
auto-generated IPv6 link-local addresses. Opaque interface identifiers will also
be used for IPv6 addresses auto-generated via SLAAC in a later change.
Note, this change does not handle retries in response to DAD conflicts yet.
That will also come in a later change.
Tests: Test that when configured to generated opaque IIDs, they are properly
generated as outlined by RFC 7217.
PiperOrigin-RevId: 288035349
|
|
PiperOrigin-RevId: 287217899
|
|
Added the ability to get/set the IP_RECVTOS socket option on UDP endpoints. If
enabled, TOS from the incoming Network Header passed as ancillary data in the
ControlMessages.
Test:
* Added unit test to udp_test.go that tests getting/setting as well as
verifying that we receive expected TOS from incoming packet.
* Added a syscall test
PiperOrigin-RevId: 287029703
|
|
This change supports clearing all host-only NDP state when NICs become routers.
All discovered routers, discovered on-link prefixes and auto-generated addresses
will be invalidated when becoming a router. This is because normally, routers do
not process Router Advertisements to discover routers or on-link prefixes, and
do not do SLAAC.
Tests: Unittest to make sure that all discovered routers, discovered prefixes
and auto-generated addresses get invalidated when transitioning from a host to
a router.
PiperOrigin-RevId: 286902309
|