| Age | Commit message (Collapse) | Author |
|---|
|
|
|
Because the code handles a bad header as "payload" right up to the last moment
we need to make sure payload handling does not remove the error information.
Fixes #4909
PiperOrigin-RevId: 344141690
|
|
|
|
The IGMPv2 core state machine can be shared with MLDv1 since they are
almost identical, ignoring specific addresses, constants and packets.
Bug #4682, #4861
PiperOrigin-RevId: 344102615
|
|
|
|
PiperOrigin-RevId: 344009602
|
|
|
|
Bug #4682
PiperOrigin-RevId: 343993297
|
|
|
|
Added headers, stats, checksum parsing capabilities from RFC 2236 describing
IGMPv2.
IGMPv2 state machine is implemented for each condition, sending and receiving
IGMP Membership Reports and Leave Group messages with backwards compatibility
with IGMPv1 routers.
Test:
* Implemented igmp header parser and checksum calculator in header/igmp_test.go
* ipv4/igmp_test.go tests incoming and outgoing IGMP messages and pathways.
* Added unit test coverage for IGMPv2 RFC behavior + IGMPv1 backwards
compatibility in ipv4/igmp_test.go.
Fixes #4682
PiperOrigin-RevId: 343408809
|
|
|
|
Found by a Fuzzer.
Reported-by: syzbot+619fa10be366d553ef7f@syzkaller.appspotmail.com
PiperOrigin-RevId: 343379575
|
|
|
|
Group addressable endpoints can simply check if it has joined the
multicast group without maintaining address endpoints. This also
helps remove the dependency on AddressableEndpoint from
GroupAddressableEndpoint.
Now that group addresses are not tracked with address endpoints, we can
avoid accidentally obtaining a route with a multicast local address.
PiperOrigin-RevId: 343336912
|
|
PiperOrigin-RevId: 343299993
|
|
Redefine stack.WritePacket into stack.WritePacketToRemote which lets the NIC
decide whether to append link headers.
PiperOrigin-RevId: 343071742
|
|
|
|
- Make AddressableEndpoint optional for NetworkEndpoint.
Not all NetworkEndpoints need to support addressing (e.g. ARP), so
AddressableEndpoint should only be implemented for protocols that
support addressing such as IPv4 and IPv6.
With this change, tcpip.ErrNotSupported will be returned by the stack
when attempting to modify addresses on a network endpoint that does
not support addressing.
Now that packets are fully handled at the network layer, and (with this
change) addresses are optional for network endpoints, we no longer need
the workaround for ARP where a fake ARP address was added to each NIC
that performs ARP so that packets would be delivered to the ARP layer.
PiperOrigin-RevId: 342722547
|
|
|
|
- Pass a PacketBuffer directly instead of releaseCB
- No longer pass a VectorisedView, which is included in the PacketBuffer
- Make it an error if data size is not equal to (last - first + 1)
- Set the callback for the reassembly timeout on NewFragmentation
PiperOrigin-RevId: 342702432
|
|
|
|
PiperOrigin-RevId: 342366891
|
|
|
|
If the packet must no longer be forwarded because its TTL/Hop Limit
reaches 0, send an ICMP Time Exceeded error to the source.
Required as per relevant RFCs. See comments in code for RFC references.
Fixes #1085
Tests:
- ipv4_test.TestForwarding
- ipv6.TestForwarding
PiperOrigin-RevId: 342323610
|
|
|
|
RELNOTES: n/a
PiperOrigin-RevId: 342176296
|
|
Add a unit test for ipv4.Encode and a round trip test.
PiperOrigin-RevId: 342169517
|
|
|
|
The NIC should not hold network-layer state or logic - network packet
handling/forwarding should be performed at the network layer instead
of the NIC.
Fixes #4688
PiperOrigin-RevId: 342166985
|
|
|
|
Most packets don't have options but they are an integral part of the
standard. Teaching the ipv4 code how to handle them will simplify future
testing and use. Because Options are so rare it is worth making sure
that the extra work is kept out of the fast path as much as possible.
Prior to this change, all usages of the IHL field of the IPv4Fields/Encode
system set it to the same constant value except in a couple of tests
for bad values. From this change IHL will not be a constant as it will
depend on the size of any Options. Since ipv4.Encode() now handles the
options it becomes a possible source of errors to let the callers set
this value, so remove it entirely and calculate the value from the size
of the Options if present (or not) therefore guaranteeing a correct value.
Fixes #4709
RELNOTES: n/a
PiperOrigin-RevId: 341864765
|
|
|
|
This change adds a Subnet() method to AddressableEndpoint so that we
can avoid repeated calls to AddressableEndpoint.AddressWithPrefix().Subnet().
Updates #231
PiperOrigin-RevId: 340969877
|
|
|
|
* Remove stack.Route from incoming packet path.
There is no need to pass around a stack.Route during the incoming path
of a packet. Instead, pass around the packet's link/network layer
information in the packet buffer since all layers may need this
information.
* Support address bound and outgoing packet NIC in routes.
When forwarding is enabled, the source address of a packet may be bound
to a different interface than the outgoing interface. This change
updates stack.Route to hold both NICs so that one can be used to write
packets while the other is used to check if the route's bound address
is valid. Note, we need to hold the address's interface so we can check
if the address is a spoofed address.
* Introduce the concept of a local route.
Local routes are routes where the packet never needs to leave the stack;
the destination is stack-local. We can now route between interfaces
within a stack if the packet never needs to leave the stack, even when
forwarding is disabled.
* Always obtain a route from the stack before sending a packet.
If a packet needs to be sent in response to an incoming packet, a route
must be obtained from the stack to ensure the stack is configured to
send packets to the packet's source from the packet's destination.
* Enable spoofing if a stack may send packets from unowned addresses.
This change required changes to some netgophers since previously,
promiscuous mode was enough to let the netstack respond to all
incoming packets regardless of the packet's destination address. Now
that a stack.Route is not held for each incoming packet, finding a route
may fail with local addresses we don't own but accepted packets for
while in promiscuous mode. Since we also want to be able to send from
any address (in response the received promiscuous mode packets), we need
to enable spoofing.
* Skip transport layer checksum checks for locally generated packets.
If a packet is locally generated, the stack can safely assume that no
errors were introduced while being locally routed since the packet is
never sent out the wire.
Some bugs fixed:
- transport layer checksum was never calculated after NAT.
- handleLocal didn't handle routing across interfaces.
- stack didn't support forwarding across interfaces.
- always consult the routing table before creating an endpoint.
Updates #4688
Fixes #3906
PiperOrigin-RevId: 340943442
|
|
PiperOrigin-RevId: 339721152
|
|
Use the stack clock instead. Change NeighborEntry.UpdatedAt to
UpdatedAtNanos.
PiperOrigin-RevId: 339520566
|
|
|
|
IPv4 options extend the size of the IP header and have a basic known
format. The framework can process that format without needing to know
about every possible option. We can add more code to handle additional
option types as we need them. Bad options or mangled option entries
can result in ICMP Parameter Problem packets. The first types we
support are the Timestamp option and the Record Route option, included
in this change.
The options are processed at several points in the packet flow within
the Network stack, with slightly different requirements. The framework
includes a mechanism to control this at each point. Support has been
added for such points which are only present in upcoming CLs such as
during packet forwarding and fragmentation.
With this change, 'ping -R' and 'ping -T' work against gVisor and Fuchsia.
$ ping -R 192.168.1.2
PING 192.168.1.2 (192.168.1.2) 56(124) bytes of data.
64 bytes from 192.168.1.2: icmp_seq=1 ttl=64 time=0.990 ms
NOP
RR: 192.168.1.1
192.168.1.2
192.168.1.1
$ ping -T tsprespec 192.168.1.2 192.168.1.1 192.168.1.2
PING 192.168.1.2 (192.168.1.2) 56(124) bytes of data.
64 bytes from 192.168.1.2: icmp_seq=1 ttl=64 time=1.20 ms
TS: 192.168.1.2 71486821 absolute
192.168.1.1 746
Unit tests included for generic options, Timestamp options
and Record Route options.
PiperOrigin-RevId: 339379076
|
|
...instead of passing its fields piecemeal.
PiperOrigin-RevId: 339345899
|
|
|
|
Fixes #4427, #4428
PiperOrigin-RevId: 338805047
|
|
|
|
Previously, the NIC local address used when completing link resolution
was held in the neighbor entry. A neighbor is not identified by any
NIC local address so remove it.
PiperOrigin-RevId: 338699695
|
|
|
|
Previously a link endpoint was passed to
stack.LinkAddressResolver.LinkAddressRequest. With this change,
implementations that want a route for the link address request may
find one through the stack. Other implementations that want to send
a packet without a route may continue to do so using the network
interface directly.
Test: - arp_test.TestLinkAddressRequest
- ipv6.TestLinkAddressRequest
PiperOrigin-RevId: 338577474
|
|
|
|
Also enforce the minimum MTU for IPv4 and IPv6, and discard packets if the
minimum is not met.
PiperOrigin-RevId: 338404225
|
|
|
|
The IPv4 header checksum has not been checked, at least in recent times,
so add code to do so. Fix all the tests that fail because they never
needed to set the checksum.
Fixes #4484
PiperOrigin-RevId: 337556243
|
