Age | Commit message (Collapse) | Author |
|
|
|
...to conform with Linux's `accept_ra` sysctl option.
```
accept_ra - INTEGER
Accept Router Advertisements; autoconfigure using them.
It also determines whether or not to transmit Router
Solicitations. If and only if the functional setting is to
accept Router Advertisements, Router Solicitations will be
transmitted.
Possible values are:
0 Do not accept Router Advertisements.
1 Accept Router Advertisements if forwarding is disabled.
2 Overrule forwarding behaviour. Accept Router Advertisements
even if forwarding is enabled.
Functional default: enabled if local forwarding is disabled.
disabled if local forwarding is enabled.
```
PiperOrigin-RevId: 372214640
|
|
Before this change, we would silently drop packets when unable to determine a
route to the destination host. This change brings us into line with RFC 792
(IPv4) and RFC 4443 (IPv6), both of which specify that gateways should return
an ICMP error to the sender when unable to reach the destination.
Startblock:
has LGTM from asfez
and then
add reviewer ghanan
PiperOrigin-RevId: 372214051
|
|
|
|
...to match linux behaviour:
```
$ sudo sysctl net.ipv6.conf.eno1.forwarding
net.ipv6.conf.eno1.forwarding = 0
$ ip addr list dev eno1
2: eno1: <...> ...
inet6 PREFIX:TEMP_IID/64 scope global temporary dynamic
valid_lft 209363sec preferred_lft 64024sec
inet6 PREFIX:GLOBAL_STABLE_IID/64 scope global dynamic mngtmpaddr ...
valid_lft 209363sec preferred_lft 209363sec
inet6 fe80::LINKLOCAL_STABLE_IID/64 scope link
valid_lft forever preferred_lft forever
$ sudo sysctl -w "net.ipv6.conf.all.forwarding=1"
net.ipv6.conf.all.forwarding = 1
$ sudo sysctl net.ipv6.conf.eno1.forwarding
net.ipv6.conf.eno1.forwarding = 1
$ ip addr list dev eno1
2: eno1: <...> ...
inet6 PREFIX:TEMP_IID/64 scope global temporary dynamic
valid_lft 209339sec preferred_lft 64000sec
inet6 PREFIX:GLOBAL_STABLE_IID/64 scope global dynamic mngtmpaddr ...
valid_lft 209339sec preferred_lft 209339sec
inet6 fe80::LINKLOCAL_STABLE_IID/64 scope link
valid_lft forever preferred_lft forever
$ ip -6 route list
...
PREFIX::/64 dev eno1 proto ra metric 100 expires 209241sec pref medium
default via fe80::ROUTER_IID dev eno1 proto ra ...
```
PiperOrigin-RevId: 372146689
|
|
|
|
Fixes the below linting error:
```
From Golint:
> Package ip has package comment defined in multiple places:
> duplicate_address_detection.go
> generic_multicast_protocol.go
```
PiperOrigin-RevId: 371430486
|
|
|
|
... it may now invalidate backing slice references
This is currently safe because TrimFront() in VectorisedView only shrinks the
view. This may not hold under the a different buffer implementation.
Reordering method calls order to allow this.
PiperOrigin-RevId: 371167610
|
|
|
|
With this change, GSO options no longer needs to be passed around as
a function argument in the write path.
This change is done in preparation for a later change that defers
segmentation, and may change GSO options for a packet as it flows
down the stack.
Updates #170.
PiperOrigin-RevId: 369774872
|
|
|
|
This is done for IPv4, UDP and TCP headers.
This also changes the packet checkers used in tests to error on
zero-checksum, not sure why it was allowed before.
And while I'm here, make comments' case consistent.
RELNOTES: n/a
Fixes #5049
PiperOrigin-RevId: 369383862
|
|
This was semi-automated -- there are many addresses that were not replaced.
Future commits should clean those up.
Parse4 and Parse6 were given their own package because //pkg/test can introduce
dependency cycles, as it depends transitively on //pkg/tcpip and some other
netstack packages.
PiperOrigin-RevId: 368726528
|
|
|
|
The current SNAT implementation has several limitations:
- SNAT source port has to be specified. It is not optional.
- SNAT source port range is not supported.
- SNAT for UDP is a one-way translation. No response packets
are handled (because conntrack doesn't support UDP currently).
- SNAT and REDIRECT can't work on the same connection.
Fixes #5489
PiperOrigin-RevId: 367750325
|
|
|
|
To match the V4 variant.
PiperOrigin-RevId: 367691981
|
|
|
|
As per RFC 3927 section 7 and RFC 4291 section 2.5.6.
Test: forward_test.TestMulticastForwarding
PiperOrigin-RevId: 367519336
|
|
|
|
See comments inline code for rationale.
Test: ip_test.TestJoinLeaveAllRoutersGroup
PiperOrigin-RevId: 367449434
|
|
|
|
...as per RFC 2710 section 5 page 10.
Test: ipv6_test.TestMLDSkipProtocol
PiperOrigin-RevId: 367031126
|
|
On Linux these are meant to be equivalent to POLLIN/POLLOUT. Rather
than hack these on in sys_poll etc it felt cleaner to just cleanup
the call sites to notify for both events. This is what linux does
as well.
Fixes #5544
PiperOrigin-RevId: 364859977
|
|
|
|
This change sets the inner `routeInfo` struct to be a named private member
and replaces direct access with access through getters. Note that direct
access to the fields of `routeInfo` is still possible through the `RouteInfo`
struct.
Fixes #4902
PiperOrigin-RevId: 364822872
|
|
|
|
|
|
...instead of opting out of them.
Loopback traffic should be stack-local but gVisor has some clients
that depend on the ability to receive loopback traffic that originated
from outside of the stack. Because of this, we guard this change behind
IP protocol options.
A previous change provided the facility to deny these martian loopback
packets but this change requires client to opt-in to accepting martian
loopback packets as accepting martian loopback packets are not meant
to be accepted, as per RFC 1122 section 3.2.1.3.g:
(g) { 127, <any> }
Internal host loopback address. Addresses of this form
MUST NOT appear outside a host.
PiperOrigin-RevId: 364581174
|
|
|
|
PiperOrigin-RevId: 364381970
|
|
|
|
Loopback traffic should be stack-local but gVisor has some clients
that depend on the ability to receive loopback traffic that originated
from outside of the stack. Because of this, we guard this change behind
IP protocol options.
Test: integration_test.TestExternalLoopbackTraffic
PiperOrigin-RevId: 363461242
|
|
|
|
...as per RFC 7527.
If a looped-back DAD message is received, do not fail DAD since our own
DAD message does not indicate that a neighbor has the address assigned.
Test: ndp_test.TestDADResolveLoopback
PiperOrigin-RevId: 363224288
|
|
|
|
Calling into the stack from LinkAddressRequest is not needed as we
already have a reference to the network endpoint (IPv6) or network
interface (IPv4/ARP).
PiperOrigin-RevId: 363213973
|
|
|
|
IPv4 would violate the lock ordering of protocol > endpoint when closing
network endpoints by calling `ipv4.protocol.forgetEndpoint` while
holding the network endpoint lock.
PiperOrigin-RevId: 361232817
|
|
|
|
The integrator may be interested in who owns a duplicate address so
pass this information (if available) along.
Fixes #5605.
PiperOrigin-RevId: 361213556
|
|
|
|
While I'm here, update NDPDispatcher.OnDuplicateAddressDetectionStatus to
take a DADResult and rename it to OnDuplicateAddressDetectionResult.
Fixes #5606.
PiperOrigin-RevId: 360965416
|
|
|
|
One of the preparation to decouple underlying buffer implementation.
There are still some methods that tie to VectorisedView, and they will be
changed gradually in later CLs.
This CL also introduce a new ICMPv6ChecksumParams to replace long list of
parameters when calling ICMPv6Checksum, aiming to be more descriptive.
PiperOrigin-RevId: 360778149
|
|
|
|
While I'm here, simplify the comments and unify naming of certain stats
across protocols.
PiperOrigin-RevId: 360728849
|
|
|
|
Fixes #5490
PiperOrigin-RevId: 359401532
|