| Age | Commit message (Collapse) | Author |
|---|
|
|
|
RELNOTES: n/a
PiperOrigin-RevId: 342176296
|
|
Add a unit test for ipv4.Encode and a round trip test.
PiperOrigin-RevId: 342169517
|
|
|
|
The NIC should not hold network-layer state or logic - network packet
handling/forwarding should be performed at the network layer instead
of the NIC.
Fixes #4688
PiperOrigin-RevId: 342166985
|
|
|
|
Most packets don't have options but they are an integral part of the
standard. Teaching the ipv4 code how to handle them will simplify future
testing and use. Because Options are so rare it is worth making sure
that the extra work is kept out of the fast path as much as possible.
Prior to this change, all usages of the IHL field of the IPv4Fields/Encode
system set it to the same constant value except in a couple of tests
for bad values. From this change IHL will not be a constant as it will
depend on the size of any Options. Since ipv4.Encode() now handles the
options it becomes a possible source of errors to let the callers set
this value, so remove it entirely and calculate the value from the size
of the Options if present (or not) therefore guaranteeing a correct value.
Fixes #4709
RELNOTES: n/a
PiperOrigin-RevId: 341864765
|
|
|
|
This change adds a Subnet() method to AddressableEndpoint so that we
can avoid repeated calls to AddressableEndpoint.AddressWithPrefix().Subnet().
Updates #231
PiperOrigin-RevId: 340969877
|
|
|
|
* Remove stack.Route from incoming packet path.
There is no need to pass around a stack.Route during the incoming path
of a packet. Instead, pass around the packet's link/network layer
information in the packet buffer since all layers may need this
information.
* Support address bound and outgoing packet NIC in routes.
When forwarding is enabled, the source address of a packet may be bound
to a different interface than the outgoing interface. This change
updates stack.Route to hold both NICs so that one can be used to write
packets while the other is used to check if the route's bound address
is valid. Note, we need to hold the address's interface so we can check
if the address is a spoofed address.
* Introduce the concept of a local route.
Local routes are routes where the packet never needs to leave the stack;
the destination is stack-local. We can now route between interfaces
within a stack if the packet never needs to leave the stack, even when
forwarding is disabled.
* Always obtain a route from the stack before sending a packet.
If a packet needs to be sent in response to an incoming packet, a route
must be obtained from the stack to ensure the stack is configured to
send packets to the packet's source from the packet's destination.
* Enable spoofing if a stack may send packets from unowned addresses.
This change required changes to some netgophers since previously,
promiscuous mode was enough to let the netstack respond to all
incoming packets regardless of the packet's destination address. Now
that a stack.Route is not held for each incoming packet, finding a route
may fail with local addresses we don't own but accepted packets for
while in promiscuous mode. Since we also want to be able to send from
any address (in response the received promiscuous mode packets), we need
to enable spoofing.
* Skip transport layer checksum checks for locally generated packets.
If a packet is locally generated, the stack can safely assume that no
errors were introduced while being locally routed since the packet is
never sent out the wire.
Some bugs fixed:
- transport layer checksum was never calculated after NAT.
- handleLocal didn't handle routing across interfaces.
- stack didn't support forwarding across interfaces.
- always consult the routing table before creating an endpoint.
Updates #4688
Fixes #3906
PiperOrigin-RevId: 340943442
|
|
PiperOrigin-RevId: 339721152
|
|
Use the stack clock instead. Change NeighborEntry.UpdatedAt to
UpdatedAtNanos.
PiperOrigin-RevId: 339520566
|
|
|
|
IPv4 options extend the size of the IP header and have a basic known
format. The framework can process that format without needing to know
about every possible option. We can add more code to handle additional
option types as we need them. Bad options or mangled option entries
can result in ICMP Parameter Problem packets. The first types we
support are the Timestamp option and the Record Route option, included
in this change.
The options are processed at several points in the packet flow within
the Network stack, with slightly different requirements. The framework
includes a mechanism to control this at each point. Support has been
added for such points which are only present in upcoming CLs such as
during packet forwarding and fragmentation.
With this change, 'ping -R' and 'ping -T' work against gVisor and Fuchsia.
$ ping -R 192.168.1.2
PING 192.168.1.2 (192.168.1.2) 56(124) bytes of data.
64 bytes from 192.168.1.2: icmp_seq=1 ttl=64 time=0.990 ms
NOP
RR: 192.168.1.1
192.168.1.2
192.168.1.1
$ ping -T tsprespec 192.168.1.2 192.168.1.1 192.168.1.2
PING 192.168.1.2 (192.168.1.2) 56(124) bytes of data.
64 bytes from 192.168.1.2: icmp_seq=1 ttl=64 time=1.20 ms
TS: 192.168.1.2 71486821 absolute
192.168.1.1 746
Unit tests included for generic options, Timestamp options
and Record Route options.
PiperOrigin-RevId: 339379076
|
|
...instead of passing its fields piecemeal.
PiperOrigin-RevId: 339345899
|
|
|
|
Fixes #4427, #4428
PiperOrigin-RevId: 338805047
|
|
|
|
Previously, the NIC local address used when completing link resolution
was held in the neighbor entry. A neighbor is not identified by any
NIC local address so remove it.
PiperOrigin-RevId: 338699695
|
|
|
|
Previously a link endpoint was passed to
stack.LinkAddressResolver.LinkAddressRequest. With this change,
implementations that want a route for the link address request may
find one through the stack. Other implementations that want to send
a packet without a route may continue to do so using the network
interface directly.
Test: - arp_test.TestLinkAddressRequest
- ipv6.TestLinkAddressRequest
PiperOrigin-RevId: 338577474
|
|
|
|
Also enforce the minimum MTU for IPv4 and IPv6, and discard packets if the
minimum is not met.
PiperOrigin-RevId: 338404225
|
|
|
|
The IPv4 header checksum has not been checked, at least in recent times,
so add code to do so. Fix all the tests that fail because they never
needed to set the checksum.
Fixes #4484
PiperOrigin-RevId: 337556243
|
|
|
|
Currently, fragmentation can only occur during WritePacket(). This enables
it for WritePackets() and WriteIncludedHeaderPacket() as well.
IPv4 unit tests were refactored to be consistent with the IPv6 unit tests.
This removes the extraHeaderReserveLength field and the related
"prependable bytes" unit tests (for both IPv4 and IPv6) because it was only
testing a panic condition when the value was too low.
Fixes #3796
PiperOrigin-RevId: 337550061
|
|
|
|
Allow writing an IPv6 packet where the IPv6 header is a provided by
the user.
* Introduce an error to let callers know a header is malformed.
We previously useed tcpip.ErrInvalidOptionValue but that did not seem
appropriate for generic malformed header errors.
* Populate network header in WriteHeaderIncludedPacket
IPv4's implementation of WriteHeaderIncludedPacket did not previously
populate the packet buffer's network header. This change fixes that.
Fixes #4527
Test: ip_test.TestWriteHeaderIncludedPacket
PiperOrigin-RevId: 337534548
|
|
|
|
RFC 4861 section 4.4 comments the Target link-layer address option is sometimes
optional in a Neighbor Advertisement packet:
"When responding to a unicast Neighbor Solicitation this option SHOULD be
included."
Tests:
pkg/tcpip/stack:stack_test
- TestEntryStaleToReachableWhenSolicitedConfirmationWithoutAddress
- TestEntryDelayToReachableWhenSolicitedConfirmationWithoutAddress
- TestEntryProbeToReachableWhenSolicitedConfirmationWithoutAddress
pkg/tcpip/network/ipv6:ipv6_test
- TestCallsToNeighborCache
PiperOrigin-RevId: 337396493
|
|
Test helpers should be used for test setup/teardown, not actual
testing. Use cmp.Diff instead of bytes.Equal to improve readability.
PiperOrigin-RevId: 337323242
|
|
|
|
This change also brings back the stack.Route.ResolveWith method so that
we can immediately resolve a route when sending an NA in response to a
a NS with a source link layer address option.
Test: ipv6_test.TestNeighorSolicitationResponse
PiperOrigin-RevId: 337185461
|
|
|
|
Remove the duplicate NA size variable while I'm here.
See https://tools.ietf.org/html/rfc4861#section-4.4 for the packet format.
PiperOrigin-RevId: 336943206
|
|
|
|
Use the correct constant (Solicit, not Advert) while I'm here.
PiperOrigin-RevId: 336924605
|
|
|
|
|
|
PiperOrigin-RevId: 336339194
|
|
|
|
PiperOrigin-RevId: 336304024
|
|
|
|
When a response needs to be sent to an incoming packet, the stack should
consult its neighbour table to determine the remote address's link
address.
When an entry does not exist in the stack's neighbor table, the stack
should queue the packet while link resolution completes. See comments.
PiperOrigin-RevId: 336185457
|
|
|
|
When the neighbor table already has link address for a neighbor but is
trying to confirm reachability, it may send unicast probes to the
neighbor.
PiperOrigin-RevId: 336166711
|
|
|
|
It was originally set to 30s for IPv6 (same as IPv4) but this is not
what RFC 8200 prescibes. Linux also defaults to 60s [1].
[1] https://github.com/torvalds/linux/blob/47ec5303d73ea344e84f46660fff693c57641386/include/net/ipv6.h#L456
PiperOrigin-RevId: 336034636
|
