Age | Commit message (Collapse) | Author |
|
Netstack's TIME-WAIT state for a TCP socket could be terminated prematurely if
the socket entered TIME-WAIT using shutdown(..., SHUT_RDWR) and then was closed
using close(). This fixes that bug and updates the tests to verify that Netstack
correctly honors TIME-WAIT under such conditions.
Fixes #3106
PiperOrigin-RevId: 326456443
|
|
Support generating temporary (short-lived) IPv6 SLAAC addresses to
address privacy concerns outlined in RFC 4941.
Tests:
- stack_test.TestAutoGenTempAddr
- stack_test.TestNoAutoGenTempAddrForLinkLocal
- stack_test.TestAutoGenTempAddrRegen
- stack_test.TestAutoGenTempAddrRegenTimerUpdates
- stack_test.TestNoAutoGenTempAddrWithoutStableAddr
- stack_test.TestAutoGenAddrInResponseToDADConflicts
PiperOrigin-RevId: 308915566
|
|
Tested:
When run on Linux, a correct ICMPv6 response is received. On netstack, no
ICMPv6 response is received.
PiperOrigin-RevId: 308343113
|
|
Tests:
- header_test.TestIsV6LinkLocalMulticastAddress
- header_test.TestScopeForIPv6Address
- stack_test.TestIPv6SourceAddressSelectionScopeAndSameAddress
PiperOrigin-RevId: 297215576
|
|
This change adds support to send NDP Router Solicitation messages when a NIC
becomes enabled as a host, as per RFC 4861 section 6.3.7.
Note, Router Solicitations will only be sent when the stack has forwarding
disabled.
Tests: Unittests to make sure that the initial Router Solicitations are sent
as configured. The tests also validate the sent Router Solicitations' fields.
PiperOrigin-RevId: 289964095
|
|
Do Source Address Selection when choosing an IPv6 source address as per RFC 6724
section 5 rules 1-3:
1) Prefer same address
2) Prefer appropriate scope
3) Avoid deprecated addresses.
A later change will update Source Address Selection to follow rules 4-8.
Tests:
Rule 1 & 2: stack.TestIPv6SourceAddressSelectionScopeAndSameAddress,
Rule 3: stack.TestAutoGenAddrTimerDeprecation,
stack.TestAutoGenAddrDeprecateFromPI
PiperOrigin-RevId: 289559373
|
|
Support generating opaque interface identifiers as defined by RFC 7217 for
auto-generated IPv6 link-local addresses. Opaque interface identifiers will also
be used for IPv6 addresses auto-generated via SLAAC in a later change.
Note, this change does not handle retries in response to DAD conflicts yet.
That will also come in a later change.
Tests: Test that when configured to generated opaque IIDs, they are properly
generated as outlined by RFC 7217.
PiperOrigin-RevId: 288035349
|
|
Fixed a bug where the interface identifier was not properly generated from an
Ethernet address.
Tests: Unittests to make sure the functions generating the EUI64 interface
identifier are correct.
PiperOrigin-RevId: 285494562
|
|
This change allows the netstack to do SLAAC as outlined by RFC 4862 section 5.5.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that SLAAC
will not be performed. See `stack.Options` and `stack.NDPConfigurations` for
more details.
This change reuses 1 option and introduces a new one that is required to take
advantage of SLAAC, all available under NDPConfigurations:
- HandleRAs: Whether or not NDP RAs are processes
- AutoGenGlobalAddresses: Whether or not SLAAC is performed.
Also note, this change does not deprecate SLAAC generated addresses after the
preferred lifetime. That will come in a later change (b/143713887). Currently,
only the valid lifetime is honoured.
Tests: Unittest to make sure that SLAAC generates and adds addresses only when
configured to do so. Tests also makes sure that conflicts with static addresses
do not modify the static address.
PiperOrigin-RevId: 284265317
|
|
This change allows the netstack to do NDP's Router Discovery as outlined by
RFC 4861 section 6.3.4.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that Router Discovery
will not be performed. See `stack.Options` and `stack.NDPConfigurations` for
more details.
This change introduces 2 options required to take advantage of Router Discovery,
all available under NDPConfigurations:
- HandleRAs: Whether or not NDP RAs are processes
- DiscoverDefaultRouters: Whether or not Router Discovery is performed
Another note: for a NIC to process Router Advertisements, it must not be a
router itself. Currently the netstack does not have per-interface routing
configuration; the routing/forwarding configuration is controlled stack-wide.
Therefore, if the stack is configured to enable forwarding/routing, no Router
Advertisements will be processed.
Tests: Unittest to make sure that Router Discovery and updates to the routing
table only occur if explicitly configured to do so. Unittest to make sure at
max stack.MaxDiscoveredDefaultRouters discovered default routers are remembered.
PiperOrigin-RevId: 278965143
|
|
This change adds support for optionally auto-generating an IPv6 link-local
address based on the NIC's MAC Address on NIC enable.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that a link-local
address will not be auto-generated unless the stack is explicitly configured.
See `stack.Options` for more details. Specifically, see
`stack.Options.AutoGenIPv6LinkLocal`.
Tests: Tests to make sure that the IPb6 link-local address is only
auto-generated if the stack is specifically configured to do so. Also tests to
make sure that an auto-generated address goes through the DAD process.
PiperOrigin-RevId: 276059813
|
|
This change adds support for Duplicate Address Detection on IPv6 addresses
as defined by RFC 4862 section 5.4.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that DAD will not be
performed. See `stack.Options` and `stack.NDPConfigurations` for more details.
Tests: Tests to make sure that the DAD process properly resolves or fails.
That is, tests make sure that DAD resolves only if:
- No other node is performing DAD for the same address
- No other node owns the same address
PiperOrigin-RevId: 275189471
|
|
PiperOrigin-RevId: 269658971
|
|
PiperOrigin-RevId: 268757842
|
|
The IPv6 all-nodes multicast address will be joined on NIC enable, and the
appropriate IPv6 solicited-node multicast address will be joined when IPv6
addresses are added.
Tests: Test receiving packets destined to the IPv6 link-local all-nodes
multicast address and the IPv6 solicted node address of an added IPv6 address.
PiperOrigin-RevId: 268047073
|
|
Adds support to generate Port Unreachable messages for UDP
datagrams received on a port for which there is no valid
endpoint.
Fixes #703
PiperOrigin-RevId: 267034418
|
|
This allows the stack to learn remote link addresses on incoming
packets, reducing the need to ARP to send responses.
This also reduces the number of round trips to the system clock,
since that may also prove to be performance-sensitive.
Fixes #739.
PiperOrigin-RevId: 265815816
|
|
This is the first step in replacing some of the redundant types with the
standard library equivalents.
PiperOrigin-RevId: 264706552
|
|
PiperOrigin-RevId: 257888338
|
|
This can be merged after:
https://github.com/google/gvisor-website/pull/77
or
https://github.com/google/gvisor-website/pull/78
PiperOrigin-RevId: 253132620
|
|
Based on the guidelines at
https://opensource.google.com/docs/releasing/authors/.
1. $ rg -l "Google LLC" | xargs sed -i 's/Google LLC.*/The gVisor Authors./'
2. Manual fixup of "Google Inc" references.
3. Add AUTHORS file. Authors may request to be added to this file.
4. Point netstack AUTHORS to gVisor AUTHORS. Drop CONTRIBUTORS.
Fixes #209
PiperOrigin-RevId: 245823212
Change-Id: I64530b24ad021a7d683137459cafc510f5ee1de9
|
|
Same as with broadcast packets, sending of a multicast packet shouldn't require
accessing the route table. The same applies to IPv6 link-local addresses, which
aren't routable at all (they don't belong to any subnet by definition).
PiperOrigin-RevId: 225775870
Change-Id: Ic53e6560c125a83be2be9c3d112e66b36e8dfe7b
|
|
PiperOrigin-RevId: 217951017
Change-Id: Ie08bf6987f98467d07457bcf35b5f1ff6e43c035
|
|
This is useful for Fuchsia.
PiperOrigin-RevId: 214619681
Change-Id: If5a60dd82365c2eae51a12bbc819e5aae8c76ee9
|
|
PiperOrigin-RevId: 212750821
Change-Id: I822fd63e48c684b45fd91f9ce057867b7eceb792
|
|
PiperOrigin-RevId: 212653818
Change-Id: Ib4e1d754d9cdddeaa428a066cb675e6ec44d91ad
|
|
Fixes #27
PiperOrigin-RevId: 203825288
Change-Id: Ie9f3a2b2c1e296b026b024f75c07da1a7e118633
|
|
PiperOrigin-RevId: 195307689
Change-Id: I499f19af49875a43214797d63376f20ae788d2f4
|
|
PiperOrigin-RevId: 194583126
Change-Id: Ica1d8821a90f74e7e745962d71801c598c652463
|