Age | Commit message (Collapse) | Author |
|
IPPacketInfo.DestinationAddr should hold the destination of the IP
packet, not the source. This change fixes that bug.
PiperOrigin-RevId: 325910766
|
|
SO_NO_CHECK is used to skip the UDP checksum generation on a TX socket
(UDP checksum is optional on IPv4).
Test:
- TestNoChecksum
- SoNoCheckOffByDefault (UdpSocketTest)
- SoNoCheck (UdpSocketTest)
Fixes #3055
PiperOrigin-RevId: 318575215
|
|
Tests now use a MinRTO of 3s instead of default 200ms. This reduced flakiness in
a lot of the congestion control/recovery tests which were flaky due to
retransmit timer firing too early in case the test executors were overloaded.
This change also bumps some of the timeouts in tests which were too sensitive to
timer variations and reduces the number of slow start iterations which can
make the tests run for too long and also trigger retansmit timeouts etc if
the executor is overloaded.
PiperOrigin-RevId: 306562645
|
|
Better validate NDP NS messages and their options before doing work in
response to them. Also make sure that NA messages sent in response to
an NS use the correct IPv6 and link-layer addresses so they are
routed properly and received by the right node.
Test: stack_test.TestNeighorSolicitationResponse
PiperOrigin-RevId: 305799054
|
|
If the NIC has a valid IPv6 address assigned, use it as the
source address for outgoing NDP Router Solicitation packets.
Test: stack_test.TestRouterSolicitation
PiperOrigin-RevId: 299398763
|
|
Added the ability to get/set the IP_RECVTCLASS socket option on UDP endpoints.
If enabled, traffic class from the incoming Network Header passed as ancillary
data in the ControlMessages.
Adding Get/SetSockOptBool to decrease the overhead of getting/setting simple
options. (This was absorbed in a CL that will be landing before this one).
Test:
* Added unit test to udp_test.go that tests getting/setting as well as
verifying that we receive expected TOS from incoming packet.
* Added a syscall test for verifying getting/setting
* Removed test skip for existing syscall test to enable end to end test.
PiperOrigin-RevId: 295840218
|
|
Test: stack_test.TestDADResolve
PiperOrigin-RevId: 292003124
|
|
This change adds support to send NDP Router Solicitation messages when a NIC
becomes enabled as a host, as per RFC 4861 section 6.3.7.
Note, Router Solicitations will only be sent when the stack has forwarding
disabled.
Tests: Unittests to make sure that the initial Router Solicitations are sent
as configured. The tests also validate the sent Router Solicitations' fields.
PiperOrigin-RevId: 289964095
|
|
PiperOrigin-RevId: 289718534
|
|
PiperOrigin-RevId: 287217899
|
|
Added the ability to get/set the IP_RECVTOS socket option on UDP endpoints. If
enabled, TOS from the incoming Network Header passed as ancillary data in the
ControlMessages.
Test:
* Added unit test to udp_test.go that tests getting/setting as well as
verifying that we receive expected TOS from incoming packet.
* Added a syscall test
PiperOrigin-RevId: 287029703
|
|
This change validates the ICMPv6 checksum field before further processing an
ICMPv6 packet.
Tests: Unittests to make sure that only ICMPv6 packets with a valid checksum
are accepted/processed. Existing tests using checker.ICMPv6 now also check the
ICMPv6 checksum field.
PiperOrigin-RevId: 276779148
|
|
This change adds support for Duplicate Address Detection on IPv6 addresses
as defined by RFC 4862 section 5.4.
Note, this change will not break existing uses of netstack as the default
configuration for the stack options is set in such a way that DAD will not be
performed. See `stack.Options` and `stack.NDPConfigurations` for more details.
Tests: Tests to make sure that the DAD process properly resolves or fails.
That is, tests make sure that DAD resolves only if:
- No other node is performing DAD for the same address
- No other node owns the same address
PiperOrigin-RevId: 275189471
|
|
Adds support to generate Port Unreachable messages for UDP
datagrams received on a port for which there is no valid
endpoint.
Fixes #703
PiperOrigin-RevId: 267034418
|
|
This can be merged after:
https://github.com/google/gvisor-website/pull/77
or
https://github.com/google/gvisor-website/pull/78
PiperOrigin-RevId: 253132620
|
|
Based on the guidelines at
https://opensource.google.com/docs/releasing/authors/.
1. $ rg -l "Google LLC" | xargs sed -i 's/Google LLC.*/The gVisor Authors./'
2. Manual fixup of "Google Inc" references.
3. Add AUTHORS file. Authors may request to be added to this file.
4. Point netstack AUTHORS to gVisor AUTHORS. Drop CONTRIBUTORS.
Fixes #209
PiperOrigin-RevId: 245823212
Change-Id: I64530b24ad021a7d683137459cafc510f5ee1de9
|
|
PiperOrigin-RevId: 217951017
Change-Id: Ie08bf6987f98467d07457bcf35b5f1ff6e43c035
|
|
PiperOrigin-RevId: 212757571
Change-Id: I04200df9e45c21eb64951cd2802532fa84afcb1a
|
|
PiperOrigin-RevId: 212750821
Change-Id: I822fd63e48c684b45fd91f9ce057867b7eceb792
|
|
Fixes #27
PiperOrigin-RevId: 203825288
Change-Id: Ie9f3a2b2c1e296b026b024f75c07da1a7e118633
|
|
PiperOrigin-RevId: 194583126
Change-Id: Ica1d8821a90f74e7e745962d71801c598c652463
|