2 files changed, 0 insertions, 39 deletions
diff --git a/images/basic/ping6test/Dockerfile b/images/basic/ping6test/Dockerfile
deleted file mode 100644
index cb740bd60..000000000
--- a/images/basic/ping6test/Dockerfile
+++ /dev/null
@@ -1,7 +0,0 @@
-FROM ubuntu:bionic
-
-WORKDIR /root
-COPY ping6.sh .
-RUN chmod +x ping6.sh
-
-RUN apt-get update && apt-get install -y iputils-ping iproute2
diff --git a/images/basic/ping6test/ping6.sh b/images/basic/ping6test/ping6.sh
deleted file mode 100644
index 4268951d0..000000000
--- a/images/basic/ping6test/ping6.sh
+++ /dev/null
@@ -1,32 +0,0 @@
-#!/bin/bash
-
-# Copyright 2020 The gVisor Authors.
-#
-# Licensed under the Apache License, Version 2.0 (the "License");
-# you may not use this file except in compliance with the License.
-# You may obtain a copy of the License at
-#
-#     http://www.apache.org/licenses/LICENSE-2.0
-#
-# Unless required by applicable law or agreed to in writing, software
-# distributed under the License is distributed on an "AS IS" BASIS,
-# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-# See the License for the specific language governing permissions and
-# limitations under the License.
-
-set -euo pipefail
-
-# Enable ipv6 on loopback if it's not already enabled. Runsc doesn't enable ipv6
-# loopback unless an ipv6 address was assigned to the container, which docker
-# does not do by default.
-if ! [[ $(ip -6 addr show dev lo) ]]; then
-  ip addr add ::1 dev lo
-fi
-
-# The docker API doesn't provide for starting a container, running a command,
-# and getting the exit status of the command in one go. The most straightforward
-# way to do this is to verify the output of the command, so we output nothing on
-# success and an error message on failure.
-if ! out=$(/bin/ping6 -c 10 ::1); then
-  echo "$out"
-fi