| Age | Commit message (Collapse) | Author |
|---|
|
The new MRT protocol is responsible for periodic RIB table dumps in the
MRT format (RFC 6396). Also the existing code for BGP4MP MRT dumps is
refactored and splitted between BGP to MRT protocols, will be more
integrated into MRT in the future.
Example:
protocol mrt {
table "*";
filename "%N_%F_%T.mrt";
period 60;
}
It is partially based on the old MRT code from Pavel Tvrdik.
|
|
The old code does not cause GR if BFD failed when GR is running,
session is re-established but not yet synchronized.
|
|
When use of LLGR is negotiated, handle hold timeout by LLGR instead of by
hard restart. Allow to configure whether BFD session down event should be
handled by GR/LLGR or by hard restart.
|
|
The patch implements long-lived graceful restart for BGP, namely
draft-uttaro-idr-bgp-persistence-03.
|
|
The patch implements BGP Administrative Shutdown Communication (RFC 8203)
allowing BGP operators to pass messages related to BGP session
administrative shutdown/restart. It handles both transmit and receive of
shutdown messages. Messages are logged and may be displayed by show
protocol all command.
Thanks to Job Snijders for the basic patch.
|
|
Actually much simpler than expected.
|
|
Add basic VRF (virtual routing and forwarding) support. Protocols can be
associated with VRFs, such protocols will be restricted to interfaces
assigned to the VRF (as reported by Linux kernel) and will use sockets
bound to the VRF. E.g., different multihop BGP instances can use diffent
kernel routing tables to handle BGP TCP connections.
The VRF support is preliminary, currently there are several limitations:
- Recent Linux kernels (4.11) do not handle correctly sockets bound
to interaces that are part of VRF, so most protocols other than multihop
BGP do not work. This will be fixed by future kernel versions.
- Neighbor cache ignores VRFs. Breaks config with the same prefix on
local interfaces in different VRFs. Not much problem as single hop
protocols do not work anyways.
- Olock code ignores VRFs. Breaks config with multiple BGP peers with the
same IP address in different VRFs.
- Incoming BGP connections are not dispatched according to VRFs.
Breaks config with multiple BGP peers with the same IP address in
different VRFs. Perhaps we would need some kernel API to read VRF of
incoming connection? Or probably use multiple listening sockets in
int-new branch.
- We should handle master VRF interface up/down events and perhaps
disable associated protocols when VRF goes down. Or at least disable
associated interfaces.
- Also we should check if the master iface is really VRF iface and
not some other kind of master iface.
- BFD session request dispatch should be aware of VRFs.
- Perhaps kernel protocol should read default kernel table ID from VRF
iface so it is not necessary to configure it.
- Perhaps we should have per-VRF default table.
|
|
This may be useful if multple interfaces share the same network range.
Thanks to Fritz Grimpen for the original patch.
|
|
Prefix and bucket tables are initialized when entering established state
but not explicitly freed when leaving it (that is handled by protocol
restart). With graceful restart, BGP may enter and leave established
state multiple times without hard protocol restart causing memory leak.
|
|
There are several unresolved -Wmissing-field-initializers on older
versions of GCC than 5.1, all of them false positive.
|
|
Add code for manipulation with TCP-MD5 keys in the IPsec SA/SP database
at FreeBSD systems. Now, BGP MD5 authentication (RFC 2385) keys are
handled automatically on both Linux and FreeBSD.
Based on patches from Pavel Tvrdik.
|
|
Event cycle may took too much time and trigger next timer events, so
avoid cycling between timer and event cycles inside the loop cycle.
|
|
In BIRD, RX has lower priority than TX with the exception of RX from
control socket. The patch replaces heuristic based on socket type with
explicit mark and uses it for both control socket and BGP session waiting
to be established.
This should avoid an issue when during heavy load, outgoing connection
could connect (TX event), send open, but then failed to receive OPEN /
establish in time, not sending notifications between and therefore
got hold timer expired error from the neighbor immediately after it
finally established the connection.
|
|
When a BGP session was established by an outgoing connection with
Graceful Restart behavior negotiated, a pending incoming connection in
OpenSent state, and another incoming connection was received, then the
outgoing connection (and whole BGP session) was closed, but the old
incoming connection was just overwritten by the new one. That later
caused a crash when the hold timer from the old connection fired.
|
|
Implements draft-ietf-idr-bgp-extended-messages-10, for now
undocumented and with temporary private capability number.
|
|
Kernel option 'merge paths' allows to merge routes exported to kernel
protocol (currently BGP and static routes) to multipath routes.
|
|
Also hook feed_done is renamed to feed_end.
|
|
Also update log message for error-triggered startup delay.
|
|
Permit specifying neighbor address, AS number and port independently.
Add 'interface' parameter for specifying interface for link-local
sessions independently.
Thanks to Alexander V. Chernikov for the original patch.
|
|
Make proto_config_new() use this info instead of supplied size.
Thanks to Alexander V. Chernikov for the patch.
|
|
Thanks to Alexander V. Chernikov for the patch.
|
|
|
|
Configurable fast shutdown of a BGP session when an interface loses link.
|
|
|
|
Thanks to João Taveira Araújo for the original patch.
|
|
|
|
|
|
|
|
Also significant core protocol state changes needed for that,
global graceful restart recovery state and kernel proto support
for recovery.
|
|
|
|
|
|
|
|
Fixes some bugs and uses generic hash implementation.
|
|
|
|
This is more consistent with common usage and also with the behavior of
other implementations (Cisco, Juniper).
Also changes the default for gw mode to be based solely on
direct/multihop.
|
|
Conflicts:
filter/filter.c
nest/proto.c
nest/rt-table.c
proto/bgp/bgp.h
proto/bgp/config.Y
|
|
|
|
Supports OSPF and BGP and also statically configured sessions.
|
|
Neighbor events related to received route next hops got mixed up with
sticky neighbor node for an IP of the BGP peer. If a neighbor for a next
hop disappears, BGP session is shut down.
|
|
If TX buffers were full during BGP session shutdown
then a protocol waited indefinitely to be able to
send notification packet to close the session.
|
|
Thanks to Fritz Grimpen for the bugfix.
|
|
They have different behavior w.r.t. filtered routes that are kept.
|
|
Router ID could be automatically determined based of subset of
ifaces/addresses specified by 'router id from' option. The patch also
does some minor changes related to router ID reconfiguration.
Thanks to Alexander V. Chernikov for most of the work.
|
|
|
|
When 'import keep rejected' protocol option is activated, routes
rejected by the import filter are kept in the routing table, but they
are hidden and not propagated to other protocols. It is possible to
examine them using 'show route rejected'.
|
|
Allows to send and receive multiple routes for one network by one BGP
session. Also contains necessary core changes to support this (routing
tables accepting several routes for one network from one protocol).
It needs some more cleanup before merging to the master branch.
|
|
|
|
Conflicts:
nest/config.Y
nest/rt-table.c
proto/bgp/bgp.c
|
|
|
|
And also fixes some minor bugs in limits.
|
